20 Most Recent
2004 Chrysler Voyager - Page 2 Questions & Answers
I have a grand voyager
dont go through all the hassles of removing the door trim just take the terminal off the battery for about a minute then reconect again worked on mine good luck
Constant black smoke whenever accelerator is used?
Too much gas going through the engine-that's why black smoke. That's all your unburned gas going out the exhaust. Have the fuel pressure tested. A failed pressure regulator will pull extra gas into the engine. Pull off the vacuum hose to the regulator. If any evidence of gas in the hose, the regulator's diaphragm has broken and sucking gas through the hose into intake.If fuel pressure is correct, have a scan done for trouble codes.
What is tcm po888 code means
code P0888 = relay output always off
this code refers to the transmission control relay output circuit in the power control module, when the relay is commanded to turn on the PCM is not seeing the relay power on, most of the time when we see this code, it can be cured by doing a re-flash on the power control module, this has to be done by the dealer.
The engine management light has come on and the car is running lumpy
HelloWhen the service engine
soon light (Also called the check engine light or engine management
light) is turned on this is to alert you to the fact that Powertrain
Control Module (computer) has detected a failure somewhere in the
systems it controls you may not feel any difference in the way the
engine runs, this can be the transmission or the engine or emission
system, there are fault codes set in the modules memory for these
faults. What needs to happen now is to have the powertrain control
module scanned with a special tool called an OBD2 electronic engine
control scanner or a OBD2 code reader. Once the code(s) are read then
you must perform the diagnostics for each code and make the
appropriate repairs based on the findings of the diagnosis that was
performed, this is called doing "Pinpoint" testing.
2004 chrysler voyager stereo and all power windows not working
there could be a wire disconnected from the switch to the windows there is a connection that goes into the back of the radio the connection might not be fitting right so you may have to get a new 1 take out the radio and look at the connection then you will find out if it is the connection
Not finding what you are looking for?