20 Most Recent
2003 Chrysler Concorde Questions & Answers
Battery removal
The battery is located under the right front fender behind the tire. Remove the wheel, remove access panel from fender well. From engine compartment, remove 2 battery hold down bolts,10mm, slide battery rearward to remove battery cables.
Car horn doesn't work, airbag light on, but car alarm works
The problem is likely with the clockspring in the steering column. The wiring for the horn button and the driver's air bag go through the clockspring. If you want to fix it yourself, I can probably find the procedure for you, but this is really a job for a professional auto electrician.
My Trac Off light is on and so is my ABS light.
You are going to need to either replace your abs sensors or your entire wheel bearing and the abs sensor will be included... What the abs sensor does is tell the computer when the wheel is turning or locked, if the abs sensor is bad the computer will not know if the wheel is turning or not, so this will also interact with your traction control.
What is P0871?
PO871: Trans Fluid Pressure Sensor/Switch C Range/Performance.I bet this is an external sensor that can be replaced from the outside of the trans.(I didn't work on automatics at the dealer-we had 2 specialists that repaired automatic transmissions.You can see why I prefer 3 pedals under my dash!)
2003 chrysler concord nocks pings left side
Knocking and pinging are two separate things. "Knocking" usually refers to the sound an engine makes when internal mechanical parts, such as piston rod bearings or connecting rod bearings, begin to wear and cause a deep "knock, knock, knock" sound during engine rotation. "Pinging" refers to the tapping sound you get upon acceleration, either when using fuel that is to loo octane for the vehicle, or when static timing is set too far advanced, or when the cylinder heads are overheating due to clogged water channels or thin oil.
If you are hearing KNOCKING on the left side, it is likely time for an engine rebuild. If you are hearing PINGING, you may need a better grade of fuel, or you are way overdue for either an oil change or a major tune-up.
How do i replace an alternator on a 2003 Chrysler concord myself?
How do you know Alternator is bad? Some Auto parts stores
will help diagnose. If that's the information source they may help you understand what to do, especially if you buy the replacement from them. youtube may have a video about how to do it.
Library should have a repair manual.
You will need wrenches. There are several tensioning devices that keep the belt tight. they need to be loosened first. The battery needs to be disconnected first. Wires need to be labeled or coded with paint so you know how return wires to the correct terminals. or take picture before you remove. Attachment bolts remove.
All bolts will be very tight, you may be able to rent or borrow (with big deposit) necessary tools from Autoparts store. Family member or friend can help?
I dont have enough clearance to remove oil pan out
Daniel ,truly god bless you ,that is one heck of a job , ok with that said ,I just read that chapter just now an the only thing is that I could find is that you have it on some kind of ramps holding it up in the air , if that's it you may have to jack the frame up letting the wheels hang down giving you more clearance ,you can also try undoing the motor mounts and tranny mount and jack up motor ,and yes there is little to grab to do this and trust me the book isn't much more help . I REALLY hope this gives you the help you wanted ,good luck .
Woody. P.S. get back to me if theres any thing elese I can do.
Not finding what you are looking for?