20 Most Recent 2000 Isuzu Hombre Questions & Answers

its really a GM car, end to end. no engines codes, is not true i bet , some codes take 1 to 3 trips, or dont store and if you get CEL glowing, driving too much can clear the codes. so.... that means you must scan it failing. see? sputtering is misfiring (bad spark or way to rich fuel) why do you jump all over fuel first. try spark FIRST no gas engine burn fuel right with bad spark' not one, and is first not last. ever heard of tuneup, done one in last decade. you know, spark parts? plugs and wire top list. in the rules of basics its: engine good, (compression test pass, and vacuum looks ok) then spark last fuel why do that backwards/?

A mechanic would check for voltage and ground at the connector for the sending unit in the gas tank. Could be the sending unit or the gauge or a wiring problem.

check the contacts on the bulb make sure the wire is hooked up and check for croded wire check your fuse in your fuse box and make sure it is hooked up try un hooking it then rehooking it

The freeze plugs are located in the side of the engine block.

pound out the hinge pins. Its kinda hard i think they make a tool for it otherwise a hammer and chisel. they have heads at the top like a nail. if they are worn buy new pions and bushings to reassemble

Measure across the hex or just try
different wrenches or sockets on it

If you got the tools you don't need to ask

check for fuel pressure .fuel pressure check valve located on the inlet pipe fitting, immediately before it enters the CMFI (fuel rail) assembly (towards the rear of the engine). if you got pressure proceed to check spark pull one pug and wire check for spark don't hold the wire rest tip of plug on steal surface. if you got all of the above and no start timing would be my next step. after making sure all connections on intake intake boot were properly secured.

in top of valve cover

some cars do have a bump or rollover switch or button not sure where located on that particular vehicle but your manual that is usually in your glove box should tell

under hood, passenger side by firewall

Check this How to Replace a Clutch procedure.

Good luck (remember rated this post).

The check engine light indicates there is a problem with the emissions system and has nothing to do with oil or coolant level. It can be as simple as a loose gas cap. If the engine is running fine then just keep driving and have it repaired when you get back home. You will not damage anything by continuing to drive as long as the engine is running as it should.

The hombre is just a chevy S-10. The dash lights are controlled by 2 things, the head light switch and the dimmer switch. Check them both make sure they are working correctly. www.rockauto.com

Pins are pressed in and some are squeezed at the ends with little ears so they will not work their way out. A die grinder maybe needed to remove the ears and then knock out the pins. You will need to prop the door shell up while your working in it securely too.