Top 10 2005 Suzuki Forenza Questions & Answers

2005 Suzuki Forenza Logo

Question

  • 2,118 People Helped

remove headlight assembly

How do you remove the headlight assembly

Posted by on

Answer

  • Most Helpful of 4 Answers

there is a nut on the left side of the light on drivers side,just the opposite on passenger side. you will need a deep socket. there are 2 10mm bolts on top of the assy. and on the back is a 10mm nut you will have to remove on order to remove the assy.

Posted on May 15, 2008

Question

  • 2,585 People Helped

How to repair Suzuki Forenza interior driver's door handle?

Trying to remove inner door panel without breaking hidden plastic clips. This I guess is the first step to remove broken and install new door handel.

Posted by on

Answer

  • Most Helpful of 1 Answers

you answered your own question,ease the door panel with two screwdrivers ,one either side of the plastic clip and watch for the mastic

Posted on Jan 23, 2009

Question

  • 2,965 People Helped

OBD II code P0133 (O2 bank 1 sensor 1) which

OBD II code P0133 (O2 bank 1 sensor 1) which sensor is this, before or after the convertor.
The car runs great except the check engine light came on and this is the code it displayed.

Posted by on

Answer

  • Most Helpful of 1 Answers

It is the front sensor, if your car is the type that has 2 front sensors it will be the one closest to the timing chain / belt (left hand side of engine)

Posted on Nov 27, 2009

Question

  • 1,818 People Helped

replace front wheel bearing 2006 suzuki forenza

replace front wheel bearing 2006 suzuki forenza

Posted by on

Answer

  • Most Helpful of 1 Answers

Very easy. Pull the wheel off after lifting the car on the side you're fixing. ;) Then pull the big center nut off the spindle. It's got a safety smash down you will have to lift up that's in a grove on the shaft. You will see this once the wheel is removed. Unbolt that big nut then pull off the brake rotor. The bearings are in the brake rotor and the shaft the rotor was sitting on. Change them both and be back on your way. It's a 20 min job at most for a beginner.

Posted on Sep 07, 2010

Question

  • 2,722 People Helped

check transmission fluid on a 2005 suzuki forenza

check transmission fluid on a 2005 suzuki forenza

Posted by on

Answer

  • Most Helpful of 2 Answers

I have a 2005 suzuki forenza,where is the transmission dipstick located at under the hood. Thank you!

Posted on May 23, 2012

Question

  • 4,268 People Helped

I need the diagram for

I need the diagram for the serpentine belt on a 2005 Suzuki forenza

Posted by on

Answer

  • Most Helpful of 1 Answers

HI. Here is the belt diagram you need below:
8ce6c9d.jpg

Posted on Aug 26, 2010

Question

  • 2,549 People Helped

2005 Suzuki Forenza warning light: Right side of

2005 Suzuki Forenza warning light: Right side of dash, looks like a steering wheel with exclamation point to the right of it....Power steering seems fine and fluid is full. What is this?.....Thank you!

Posted by on

Answer

  • Most Helpful of 1 Answers

Speed Sensitive Power Steering

(SSPS) Warning Light


Your vehicle is equipped with Speed Sensitive Power Steering (SSPS).

This is a computer-controlled power steering assist system.

The warning light you are describing will come on briefly when you turn the ignition to ON as a check to show you the bulb is working.

Then it should go out after a few seconds. If the warning light does not come on, have it fixed so it will be able to warn you if there is a problem.

If the warning light stays on, or comes on while you are driving, the SSPS system may not be working.
Your computer will need to be scanned to determine what the problem is with your SSPS system.

Posted on Jan 23, 2011

Question

  • 3,971 People Helped

2005 suzuki forenza how many quarts of oil does it

2005 suzuki forenza how many quarts of oil does it hold

Posted by on

Answer

  • Most Helpful of 1 Answers

2005 SUZUKI FORENZA 2.0L 4-cyl Engine Code DOHC
Engine Oil capacity with new filter is 4.3 quarts.
Be sure to recheck oil level after engine has run for 5-10 minutes. Do not overfill.
Please rate this answer by clicking on the "HANDS" below.

Posted on Feb 09, 2011

Question

  • 1,584 People Helped

I replaced the timing belt on a 05 suzuki forenza

I replaced the timing belt on a 05 suzuki forenza and not i cannot figure out which mark to use on the exhaust cam pulley

Posted by on

Answer

  • Most Helpful of 1 Answers

  • Hear are the timing marks fora a 2005 Suzuki Forenza 2.0

  • Crankshaft gear to the bottom of the rear timing belt cover ----


ironfist109_352.jpg


  • Camshaft gear to Camshaft cover ---

ironfist109_353.jpg


  • If you have any comments please feel free to leave them here.
  • Hope this helps and thank you for using FixYa.


Regards, Tony

Posted on Oct 10, 2011

Question

  • 2,529 People Helped

Need timing mark diagram for Suzuki forenza 2.0

Timing belt marks

Posted by on

Answer

  • Most Helpful of 1 Answers

old post. shows as 2016 so i bumped it.
OP fails to seach first.


http://www.fixya.com/search.aspx?ref=ser&s=forenza%20timing%20marks&


Posted on Jan 02, 2017

681 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Suzuki Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

2005 Suzuki Forenza Forenza

  • 2005 Suzuki Forenza Forenza

Most Popular Question

find camshaft sensor 2005 suzuki

  • Cars & Trucks
Loading...