20 Most Recent 2006 Jeep Grand Cherokee - Page 4 Questions & Answers

Hi Richard remove the wheels brake calliper s and mounting brackets then if there is grub screws holding the rotars remove them then get a big hammer and remove thd rotars they get atuck with rust so don't be shy with the hammer. Regards Jim...

2006 Jeep Grand... | Answered on Jun 06, 2015

The caliper needs to be removed by removing the two bolts on the back side of the caliper. Make sure that there is no kinda clip on one of the lug bolts. If the rotor is stuck a few whacks on the rear of the rotor with a rubber mallet should pop right off. I hope its a little helpful.

2006 Jeep Grand... | Answered on Jun 06, 2015

The engine light only tells you that there's a problem. You need to get the code from the computer. Most auto parts places will read your code for free. That may tell you what part needs to be replaced.

2006 Jeep Grand... | Answered on May 24, 2015

If the air flow cannot be controlled from vent/defrost/floor you may have a blend door issue. This is an electric motor that operates a door in the heating system to control airflow. There are usually 3 motors controlling airflow direction,heat and recirculation. The Ac not blowing cold may also be another problem. If the AC is operational, the compressor will be engaged and the Ac low pressure line under the hood will bw cold. If this is all ok then a blend door issue should be suspected

2006 Jeep Grand... | Answered on May 09, 2015

fuses ,test them yet?

2006 Jeep Grand... | Answered on May 03, 2015

Hi there, I'm AL the owner of Big As Auto Repair in St Charles Mo

The "Gas Cap Loose" is a common problem when someone leaves the cap slightly loose, when tightening the cap you must hear the clicks to make sure its tight. The code is there just to let you know the cap is loose.

However, I have found that the gas cap itself was leaking and in some cases the area where the cap tightens had a defect causing it to leak. Unfortunately, a smoke check is the only way to pin-point what is causing the problem. Before spending that money!

The first thing you need to do, just to make sure is replace the cap and tighten it hearing three clicks then let it run-out 40 key cycles to see if it reset, if it doesn't reset then you know you have an issue that needs to be repaired. Please send your family and friends to my website here: Auto Repair

2006 Jeep Grand... | Answered on Mar 29, 2015

my guess, is you are asking for the condensate drain the fail to say why , so we can know whats up...
yes, do put us on same page, really./
ok, its connected to the bottom of the evap core box,
in usa most are at passengers toes. (seated)
it goes to the floor and to bottom of car and you get that clear puddle of pure water there on road, as all cars do.
it's just a drain. pipe, a simple pipe.
and loves to pack with FUNGUS and MODE , due to dirt + water makes mold.
i use a coat hanger wire to back feed it and clean it
or better those home sink drains cleaner funny plastic rods,
with hooks on them. it make easy clean out.

2006 Jeep Grand... | Answered on Mar 28, 2015

to what.

2006 Jeep Grand... | Answered on Mar 16, 2015

the tire pressure must be at door jamb spec, is it?
get any tire store to scan it? it shows, pressure, temp and ID

the tire must be scanned to see why.
buy the tool
or get it scanned,
there are only 2 ways.

the jeep will autolearn new sensors. btw.
they even work parked once activated (new)
driving activates them (as they spin a switch closes to do that)

the fsm covers this,
if you need the page can send.

2006 Jeep Grand... | Answered on Mar 14, 2015

Probably the power steering pump is bad.

2006 Jeep Grand... | Answered on Mar 02, 2015

check oil pressure
using a real gauge at the engine block sender hole.
do so cranking not started.
0 PSI?
the sender (icon magic) goes on at below 3-5PSI
and 5psi is doom levels.

2006 Jeep Grand... | Answered on Feb 27, 2015

old post
i cut it all off with plasma cutter
and weld all else closed.
but im a cave man.

2006 Jeep Grand... | Answered on Feb 22, 2015

use a test light and check for power and ground at the electrical connection at the pump as if you have these then the pump is bad and needs replacing.

2006 Jeep Grand... | Answered on Feb 07, 2015

the operators manual is clear on that, did you read that first?
it says "get the car serviced" clearly
if you work on cars, do you? thne we scan the systems with the scan tool first. to see if there are complex hard errors.
like the ABS sensors, (not bas) sensor dead. (ops a road hazard hit it and broke the wire there, dang.
then if no hard failures.
first is not ESP (that be last dead last)
the first is , the brake must work perfect if not , the ABS can not
work correctly with bad brakes.
so check fuses.
scan ABS for errors
then do a full brake inspection, takes me 2 hours. but my guess,
youve never done brakes, right,, your self?
not even a full inspection?
  1. leaks? (fluid)
  2. pads worn out?
  3. caliper pistons not sticking
  4. rotors not cracked, or wrecked, surfaces.
  5. caliper guide pins not seized. (they float free?)
  6. emg, brake not sticking on partially?
  7. wrong sized tires on car (or just one , omg)
  8. ABS sensor parts damaged at axles ends.?
  9. bad wheel bearing, seizing or loose.
etc... etc.... and more.

2006 Jeep Grand... | Answered on Feb 06, 2015

Try to turn off and on your Bluetooth on your phone, uconnect might not connect your phone automatically if it's not your favourite. You can see on your settings on uconnect. If that doesn't help, take it to the dealer, it might need a quick update. Good luck

2006 Jeep Grand... | Answered on Jan 13, 2015

Best way to see if 02 sensors are working is to unplug them one at a time and see how it runs after you unplug each one.

2006 Jeep Grand... | Answered on Dec 21, 2014

There is no need to go disconnecting the battery as Leonard Javier has suggested above. If your Jeep is equipped with a driver's memory seat, the memory can be cleared at any time using the controls provided by the manufacturer.

How you would go about doing this is covered in the 2006 Jeep Grand Cherokee Owner's Manual, begining on page 114.
If you do not have an Owner's Manual for your Jeep, you can download a PDF version of it for FREE at the following URL.


2006 Jeep Grand... | Answered on Nov 25, 2014

Not finding what you are looking for?
2006 Jeep Grand Cherokee Logo

958 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Jeep Experts


Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Grand Cherokee Jeep

  • Grand Cherokee Jeep

Most Popular Question

2006 jeep grand cherokee wk heater

  • Cars & Trucks