2003 Jeep Liberty - Answered Questions & Fixed issues

If you can remove the thermostat housing and the bottom bolt is visible, you can use a vise grip to remove it.
If the bolt is broken even with the block, then you have to drill it out.

2003 Jeep... | Answered on Jun 06, 2019 | 709 views

Fuel pressure ? Bad tps switch? Have a scanner hooked up and see what is not working when this happens. Better than guessing.

2003 Jeep... | Answered on Apr 24, 2019 | 82 views

Lift the tires off the ground and spin them and check for any play in the bearings. Look at your tires. If they have flat spots on the outter edges of the tire then that is probably the noise you are hearing.

2003 Jeep... | Answered on Apr 19, 2019 | 36 views

Sounds like a ground problem allowing a back feed issue.

Make sure your battery is grounded to the engine and frame.

2003 Jeep... | Answered on Mar 09, 2019 | 79 views

it liberty google the codes

2003 Jeep... | Answered on Feb 16, 2019 | 50 views

i know a website that has very good manuals online, without expiry i.e. for
lifetime. www.reliable-store.com

2003 Jeep... | Answered on Sep 10, 2018 | 43 views

according to the code reader ????? No it doesn't ! No code say's to replace a part . Diagnose trouble code has step by step diagnostic procedures to follow ,at the end of diagnostic's it may need a new part , but till the diagnostic's are done you don't just replace a part . It's a mistake to sell code readers to people that have no clue . Do yourself a favor an take your vehicle to a quailfied repair shop

2003 Jeep... | Answered on Jun 09, 2018 | 1,305 views

If he hit you hard he probably hit the front wheel. If yes, the most likely problem is the track rod ends. These are adjustable links that connect the wheels to the steering rack assembly. They connect to the wheel hub behind the brake disc with ball joint pivots that can snap if hit too hard.
The impact from an accident can create a shock wave of damage so there could be damage to the steering rack as well as the suspension links and ball joints.

2003 Jeep... | Answered on Feb 14, 2018 | 29 views

You put in the wrong bulb and it's feeding back.

2003 Jeep... | Answered on Feb 02, 2018 | 54 views

2002 jeep liberty
I know this website reliable-store that i used to buy them from, and they sold online it was very good manual. Go ahead, I bet.

2003 Jeep... | Answered on Jan 26, 2018 | 82 views

yes right at the wiper motor.

2003 Jeep... | Answered on Jan 26, 2018 | 208 views

try disconnecting the coolant temp sensor with the key on/engine off. The Engine Coolant Temperature (ECT) sensor on the 3.7L engine is installed into a water jacket at front of intake manifold. if the fan comes on then the problem is in the sensor. You did the relay which is the most common so this is next.
hope this helps.
whoops i am assuming tis a 3.7L

2003 Jeep... | Answered on Jan 03, 2018 | 833 views

I had this problem as well , they had to reset my shifter cable

2003 Jeep... | Answered on Jan 01, 2018 | 74 views

Google "***** wobble" common on big Dodge, Ford, Chevy, and things (like Jeep's) with bigger tires and lifts as miles go up. Yours is also likey a bad wheel balance . Have the wheels balanced and watch them spin as they balance them.

2003 Jeep... | Answered on Dec 30, 2017 | 43 views

Reboot by taking of the batterm cable, wait a.minute and hook it back up. Maybe that will fix it.

2003 Jeep... | Answered on Dec 29, 2017 | 151 views

have the fault codes read as that will indicate the problem area

2003 Jeep... | Answered on Oct 29, 2017 | 246 views

Doesn't that jeep have an on board anti theft system that shuts of power to the startee and the fuel injectors. Im pretty sure it does thats where to start sometimes just turn the key to the on position for 30 sec. To 60 sec then crank the engine if that doesnt work turn off at least 10 sec try again tirn to on position without cranking motor for at least 30 sec then try cranking

2003 Jeep... | Answered on Sep 20, 2017 | 277 views

sounds like coolant and that vehicle overheated or now has a leak ---and replacing plugs usually doesnt correct an overheating problem and if told had bad thermostat [ which will cause overheating ] i would have system tested for leaks then look into thermostat as a problem to your overheating problem

2003 Jeep... | Answered on Aug 23, 2017 | 69 views

Not finding what you are looking for?
2003 Jeep Liberty Logo

1,184 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

2002 Jeep Liberty
2002 Jeep Liberty

1,622 Questions

2005 Jeep Liberty
2005 Jeep Liberty

825 Questions

2004 Jeep Liberty
2004 Jeep Liberty

719 Questions

2006 Jeep Liberty
2006 Jeep Liberty

621 Questions

Top Jeep Experts


Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides