2000 Jeep Grand Cherokee - Page 9 - Answered Questions & Fixed issues

get out the WD-40 and get to work

2000 Jeep Grand... | Answered on Jan 31, 2015 | 28 views

is this a question?

2000 Jeep Grand... | Answered on Jan 30, 2015 | 324 views

find a live mech, to find noise, nobody here will ever guess cause.
we cant hear . nor use stereoscopic hearing to tell directions.

2000 Jeep Grand... | Answered on Jan 31, 2015 | 190 views

the air conditioner
what part, it's a huge system.?
ac ( advanced commode)

2000 Jeep Grand... | Answered on Jan 30, 2015 | 21 views

DOES IT CRANK in NEUTRAL? using fresh PRNDL contacts?
no crank, is easy to diagnose. with just one tool a voltmeter.
12.6vdc is a charged battery , rested, if lower, and not cold its discharged. so charge it or jumper cable crank engine off running donor car. easy huh?
if it cant crank it cant start, (mine can push start or gravity start)
battery cable lugs clean and tight x4 ends? green corrosion?

we then hot wire. the starter solenoid, next. (using old screwdriver as jumper bar)
it cranks now (good starter ) all in 5min work !
it does not crank bad starter.

so it cranks hot wired. good.
so next what is next, easy the KEY line.
the key line runs form the starter to the PRNDL switch and then the KEY switch (crank Start line)
if the car has SKIM immobilizer it cuts fuel not spark.

so i check for 12vdc into PRNDL cranking then key is ok.
if got 12vdc in to PRNLD but not out cranking the switch is bad.
or maladjusted?
its that simple ,with any 10buck DMM off walfarts shelf.

if car is hacked or alarms spliced in, we cant fix it here, its not stock.
same with remote start hack jobs.

2000 Jeep Grand... | Answered on Jan 27, 2015 | 175 views

Faulty low pressure switch , Google it to see how to replace, or you an unlucky it and run a jumper wire between the terminals/ But beware- bypassing the low pressure switch can ruin the compressor if it gets low on freon.

2000 Jeep Grand... | Answered on Jan 25, 2015 | 126 views

If you have power to the wiper motor and the motor will not come on then your wiper motor is bad. When the wiper switch is off their should be no power to the motor. When the wiper switch is on, power is sent to the wiper motor and the wiper then turns on. The relay is use probably to control the wiper speeds you select. I hope this helps.

2000 Jeep Grand... | Answered on Jan 24, 2015 | 201 views

which engine? of the 3.
all sparks failing or just one, takes them all to run !
generic answer, starts.
check fuses first. aways.
spark, lost spark on all modern cars
you next scan the PCM using any scan tool (modern)
youj crank the engine over for 5 seconds, and you will see
DTC errors. , and the error is a BIG clue.
like DTC for dead Crank sensor, or? cam?

2000 Jeep Grand... | Answered on Jan 22, 2015 | 115 views

Seems from just a little research that this is a major problem with several years of jeeps having the same issues. Most responses i seen point to an electrical problem with the PCI Bus.
A quick fix in which I have seen several positive responses, is to disconnect the negative cable from battery and leave disconnected for approx. 10 minutes then reconnect.
Hopefully this will give you at least some short term relief.

Sources: http://forums.cnet.com/7723-7811_102-272172.html http://www.cherokeeforum.com/f2/interior-lights-staying-25200/

2000 Jeep Grand... | Answered on Jan 18, 2015 | 217 views

You need to get the transmission evaluated by a professional shop immediately. The symptoms you describe are a slipping transmission and a severe one at that. Slipping transmissions can be caused by low pressure inside the transmission which in turn can be caused by improperly installed filters (especially if this is a v8 Grand Cherokee). You could go to a quick oil change center and ask to have the transmission flushed _AND_ the filter changed. It might cure the problem... But that typically costs $120+ and a transmission shop will typically diagnose for less (half that).

Good luck.

2000 Jeep Grand... | Answered on Jan 18, 2015 | 77 views

Could be a blown fuse or a problem with the blower motor or resistor/controller, but on the AZC (automatic zone control) system, many times the problem is a melted connector on the blower motor controller. Look up in the passengers footwell area, there you will find the blower motor (fastened with three screws) and next to it the blower motor controller..

2000 Jeep Grand... | Answered on Jan 17, 2015 | 128 views

I would check the IAC stepper motor plunjer (idle air control). Dirt can build up on the plunjer and the air canal and will disturbe the idle control. The IAC sits on the throttle body.

2000 Jeep Grand... | Answered on Jan 17, 2015 | 119 views

There is not such a sensor on the transmission. That the engine shuts off could be due to a faulty crank or cam sensor.

2000 Jeep Grand... | Answered on Jan 17, 2015 | 45 views

what is a leef, ( a loose reef?) or loose reeefer?

2000 Jeep Grand... | Answered on Jan 15, 2015 | 34 views

the ACM in the control module has lost this program needs to go back to the dealership to be reprogrammed you said about a hundred To125 dollars

If you need further help, reach me via phone at https://www.6ya.com/expert/james_9c1b039055413ffa

2000 Jeep Grand... | Answered on Jan 13, 2015 | 61 views

Yes. We all learn the hard way by installing the new one backwards. Be careful to observe as you remove the old one the corrrect way to install the new one.

2000 Jeep Grand... | Answered on Jan 10, 2015 | 44 views

The water will keep blowing out this it common on this motor the cylinders compression pushes air into water jacket forcing it back out most likely it is gasket or warped head but there is a reason for this weather it water pump thermostat or cracked radiator

2000 Jeep Grand... | Answered on Jan 08, 2015 | 111 views

You will need to have it scanned to know what is failing.

2000 Jeep Grand... | Answered on Jan 07, 2015 | 33 views

you probably need a new switch unit...about $200 installed....typical jeep problem....you can try hitting just under steering wheel to see if it works for a while

2000 Jeep Grand... | Answered on Jan 03, 2015 | 23 views

Not finding what you are looking for?
2000 Jeep Grand Cherokee Logo

4,469 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Jeep Experts


Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides