20 Most Recent 2005 Chrysler Town & Country - Page 3 Questions & Answers

May be a bad ignition switch or a bad ecm( computer).

Sorry dealer only job unless you have access to the correct delphi software

Max current is 20A for the lighter/power sockets. This can be confirmed two ways -- the first is the power sockets typically have the number printed on the plastic outlet cover, the second is to look in the manual for the fuse ratings on this circuit.

Check for a blown fuse in the power circuit to the radio. If your radio is an aftermarket one, it may have been improperly installed and powered from the cigarette lighter circuit. If so, check the fuse for the cigarette lighter circuit. It may be that a "fusible link" was blown open when you attached a defective cell phone charger (what you call a "memory charger?) If so, you will have to get professional help in finding the location of the fusible link, often buried within the car's wiring harness.

the Integrated Power Module (IPM) and Front Control Module (FCM) area. Both control brake/ABS and airbag circuits. Both are infamous for corrosion problems. Try a shake test with power on meaning shake the wire harnesses on the IPM and tap the FCM watching for any changes. Still bad? Disconnect and islolate the negative battery cable then remove the FCM and check for corrosion or damaged contacts. Still broke? Do the same with the IPM connections. Still nothing? Remove the IPM, open it up and look for corrosion on the internal circuit board.------------ The IPM is not detecting few sensors or FCM is not getting in contact with IPM.------- It still indicates problem towards IPM. ----------- Click this link below and go through the wiring diagrams:---- http://howtobyme.blogspot.com/2011/08/ipm-and-fcm-module-inspection-on-2005.html ----------- This will help.Thanks.Helpmech.

How many miles on the vehicle . Time for a rebuild

Door Locks Go Crazy 1 Door Locks Go Crazy 2 Door Locks Go Crazy 3 Not to difficult to understand what's happening ,when you know how they work .Plus you need tool the proper tools to diagnose .

Under hood in the black box

How To Replace the Thermostat on 2005 Chrysler Town and Country Van

No air coming from air conditioning vents

1. Check the air conditioner fuse and replace as necessary.
2. Air conditioner system discharged. Have the system evacuated, charged and leak tested by an MVAC certified technician, utilizing approved recovery/recycling equipment. Repair as necessary.
3. Air conditioner low pressure switch defective. Replace switch.
4. Air conditioner fan resistor pack defective. Replace resistor pack.
5. Loose connection, broken wiring or defective air conditioner relay in air conditioning electrical circuit. Repair wiring or replace relay as necessary. Air conditioner has a smell when used
   1. The air conditioner evaporator drain hose is blocked or partially restricted, allowing condensation to build up around the evaporator and drainage tray. Clear the drain hose where it exits the passenger compartment.
   2. Check compressor clutch wiring, electrical connections and compressor clutch, and repair or replace as necessary.

You would need to perform the diagnostics to pin down the cause. It could be the dash switch or burned wiring connector to the switch.