20 Most Recent 2005 Chrysler 300 Questions & Answers

Hello! See diagram below of the location of Crankshaft Positioning Sensor (CPS)...It has a 3 wire connector with the following wire colors...Dark Blue/Dark Green (ground)...Dark Blue/White (signal lead)...And Pink/Yellow (+5 volts)...

Looking at the front of the engine...The left bank (front to rear) are 2, 4, 6, 8...
The right bank (front to rear) are 1, 3, 5, 7...Therefore the first cylinder on the right bank is # 1...The rear or last cylinder on the right bank is #7



I’m happy to help further over the phone at https://www.6ya.com/expert/david_6df67de3b14de867

2005 Chrysler... | Answered on Jun 16, 2019

RKE means remote keyless entry. Install a new battery in your key fob and your light will go off. Regards, Joe
ps - kindly rate my answer as helpful. thank you.

2005 Chrysler... | Answered on Feb 05, 2019

Should be fuse #4 a 20amp (yellow in color) located in the IPM (integrated power module) on passenger side engine compartment. Black cover over IPM.

2005 Chrysler... | Answered on Jun 27, 2018

didn't bother and refill the radiator
nothing gets fixed until you take the timer to have it fixed

2005 Chrysler... | Answered on Feb 23, 2018

burning oil ? leaks on the ground still ?

2005 Chrysler... | Answered on Feb 10, 2018

Very hard to diagnose nav /stereo units. Check fuse box to make sure it's getting a good power supply. Try spraying WD-40 or contact lens cleaner in the switches to see if any of them are stuck. Consider replacing entire unit w/ one from eBay, preferably with some kind of warranty. Also, check Crutchfield.com for new alternatives. A factory replacement, if you can find one, is likely to be really expensive.

2005 Chrysler... | Answered on Feb 09, 2018

It look like your ECU does not recognize the throttle body. Reasons being removal of battery for a long time. Try doing an adaption and also run a Diagnostics for other issues

2005 Chrysler... | Answered on Jan 19, 2018

you have a bearing on an accessory locked on the front of the engine e.g. alternator, idler pulley, tensioner etc.

2005 Chrysler... | Answered on Jan 01, 2018

a bad plug or wire will cause a cyl misfire. also, the emissions syst is a sealed one, so if you are prone to leaving the gas cap off at the gas station, your'e asking for trouble down the road.loose gas cap will pop a light.

2005 Chrysler... | Answered on Nov 13, 2017

If your low on antifreeze the heater core may not be getting sufficient coolant. Heater core most likely clogged if you're not low on antifreeze

2005 Chrysler... | Answered on Nov 05, 2017

Youtube may have a video showing where an how to replace it . First off did they tell you what code ? You can check the code yourself by turning the key on then off three times an the last time leave it in the on position . In the odometer ,if any codes are stored in the PCM - engine computer they will show there . P2156 P0131 code could show up to a couple hundred . Google what you see .

2005 Chrysler... | Answered on Nov 01, 2017

find an accredited service shop and get a proper diagnosis done and a quote
the suggestion from the mechanic indicates a limited knowledge and the procedure to follow in testing and problem solving

2005 Chrysler... | Answered on Oct 05, 2017

Take it back and ask to put it back to factory settings on as it was set

2005 Chrysler... | Answered on Sep 26, 2017

Have you checked the grounds ? Load test them .

2005 Chrysler... | Answered on Aug 23, 2017

Not finding what you are looking for?
2005 Chrysler 300 Logo

1,759 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Chrysler Experts


Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

300 Chrysler

  • 300 Chrysler

Most Popular Question

force specification in newton one trunk

  • Cars & Trucks