20 Most Recent 1994 Buick Regal Gran Sport Questions & Answers

Behind the dash on the right side in the component center

1994 Buick Regal... | Answered on Jan 05, 2018

It sounds like your idle control valve is sticking. The video shows you where they are located on a 97 Buick but it is the same engine.
This video shows you how to replace them.

1994 Buick Regal... | Answered on Nov 29, 2017

Have the out put voltage on you altenator checked, if it's fluctuating it may be going bad

1994 Buick Regal... | Answered on Oct 25, 2017

Best bet it Alldatadiy.com

1994 Buick Regal... | Answered on Jul 11, 2017

You mean 4,000 rpm . No engine goes 40,000 rpm . senor on the transmission that control the rpm. No SENSOR on the transmission ! Crank sensor's Take it to someone who has a tool like in the video an knows what he is looking at .
Ignition Scan data

1994 Buick Regal... | Answered on Jun 17, 2017

It is a 24 year old vehicle (made in 94), it probably needs to retire :>)

Take it to a transmission specialist rather than a normal garage, as it sounds like a sensor problem. It may also be rubber mountings that have perished, and the engine and transmission are only partially mounted to the chassis.

1994 Buick Regal... | Answered on Mar 16, 2017

The coolant temperature sensor is a thermistor mounted in the engine coolant stream. A thermistor is an electrical device that varies its resistance in relation to changes in temperature.

For 2.5L engines, the coolant temperature sensor is located on the left side of the cylinder head.

For MFI engines, the coolant temperature sensor is located on the intake manifold water jacket or near (or on) the thermostat housing.


Fig. 1: Engine Coolant Temperature (ECT) sensor and connector


Fig.: Engine Coolant Temperature (ECT) sensor location-3.1L (VIN T) engine shown

Hope this helps (remember to rating this and leave an testimonial comment about this free answer).

1994 Buick Regal... | Answered on Oct 27, 2015

I would suggest having the vehicle put on a scanner and monitor the operating parameters of the sensor for heater signal operation and sensor performance. You may not have overlooked anything. However, without knowing what the sensor is actually doing nand reading, you will be chasing your tail

1994 Buick Regal... | Answered on Oct 25, 2015

Find the radio station you would like to store. Then press and hold down the button you wish to assign to that station until you hear a BEEP. That station will then be stored to that button.

1994 Buick Regal... | Answered on Sep 04, 2015

if the switch is not working it will have to be replaced you don`t fix them. but you don`t say what problem your having with it.

1994 Buick Regal... | Answered on Jun 13, 2015

Check the battery,have a load test done on the battery,now,it could be that the battery terminals,and battery cable ends are corroded,clean them really good,shining clean,this makes a big difference.Good idea to have the alternator checked also,while on the vehicle running,with the head lights on,and high blower motor,it should read at the battery,13.65 volts,to 14.25 volts.

1994 Buick Regal... | Answered on Jun 08, 2015

If you follow up the brake pedal towards the steering column, you will see the switch.The switch can be at the front of the pedal or at the back of the pedal. It's not a difficult replacement, it's just hard to lay on your back in that small space and do the job. The part costs about $10.00. The question I have is why are you looking to replace? The faults are usually brake lights stay on which will kill your battery , or switch is bad and brake lights don't come on when pedal is depressed. I would first check for blown fuses, and blown bulbs. If you need any additional help please get back to me. GOOD LUCK FREIND.

1994 Buick Regal... | Answered on Feb 10, 2015

it is better to gut out the valve and reinstall it but it should come out with the first exhaust pipe.

1994 Buick Regal... | Answered on Dec 19, 2014

i had the same problem had to replace the turn signal switch....GM for some reason wired the brake lights through the turn signal switch. to check if this is the case with yours. put some pressure on the turn signal lever as if you were going to turn on your brights and press your brake pedal and see if the lights work at that point that is how i found mine. hope this helps. if indeed they work with pressure on the turn signal lever. the new switch cost me $60 at autozone and that is with the steering wheel radio controls, make sure you get the proper switch should be part# sw771 if you have the radio controls on steering wheel and you will need a steering wheel puller and lock plate compressing tool.

1994 Buick Regal... | Answered on May 17, 2014

You have a rod that goes from your door handle to the latch opener, inside the door panel. It has probably came off. You will need to take off your door panel to get to it. There are just a few screws on the corner of the panel. Remove them and then you will need to move the plastic and foam in the inside of the door. After this, you should be able to get to the rod. Hope this helps you.

1994 Buick Regal... | Answered on May 05, 2014

Not finding what you are looking for?
1994 Buick Regal Gran Sport Logo

333 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

1999 Buick Regal
1999 Buick Regal

756 Questions

1995 Buick Regal
1995 Buick Regal

630 Questions

1998 Buick Regal
1998 Buick Regal

488 Questions

2000 Buick Regal
2000 Buick Regal

416 Questions

2001 Buick Regal
2001 Buick Regal

423 Questions

Top Buick Experts


Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Regal Buick

  • Regal Buick

Most Popular Question

changed o2 sensor checked wiring but

  • Cars & Trucks