20 Most Recent 2006 Jeep Commander - Page 2 Questions & Answers

A dtc does not say to relace a part untill diagnostic procedure for said code is preformed . Do you know what a diagnostic trouble chart is ? Factory service repair info. is best . https://www.obd-codes.com/p0335

incorrect about the insulation it will most likely be the climate control module that has failed and needs replacing as what the dealer has stated

https://s21.postimg.org/6kfdcs4zr/integrated_power_module.jpg Click on the link. Integrated power module, under hood close to battery. Some makes and models have different names for bcm. Just my opinion.

double posted ;please add to one post. and answer the question there. all brake lamps pop on, with foot on brake all 3 on rear of car. does car drive ok. held lamps bright, heater bower work on high,sounding OK?

rear blake lamps or cluster warning lamps maked brake and or ABS. PLEASE ELABORATE POP ON /OFF???? Tell what works and not work, lights be clear all 3 rear brake lamps dead? 2 are 1 is not.or? does car drive ok? does shift'er lever move from park to drive.????

car drives perfectly, as do all other electrics? fuses good scan it is next. can fix 2005+ GC lacking tools, like this. the book is free. wk read that yet? RTM ,.read first how it works,,, its not like you think,,,? http://www.morris4x4center.com/knowledge-base/index.htm?utm_source=cj#service

if blower blows, say so.http://jeepdied.com/no-cab-heat.htmlhere is the basics. on this. pure basics.fuses good.blower blows.engine at normal hot temp, 180- 200f is normal.heat BLEND damper open? (electric motor driven damper it is.)controls not bad. (be it manual or ATC system)hot water is flowing through the heater coreand both hose hot. 150f is stated as normal in the SM.then heat happens.if car is ATC, then scan it. (means you do or they scan it, pick one?)the dials tell you if it's ATC or not.only you know and is unstated by you and matters big time. http://jeepdied.com/no-cab-heat.htmlwhy not just car car serviced like 99.9% do.why not?you dont have tools, so...

talk to THEM. you never said the recall, numbers, so... who knows what was done, only you.

A new radio or maybe your local Jeep dealer has a repair service that they can recommend to you.

be looking at emissions vacuum controls for leaks..

its in the FSM book,, posted over 300 times here. here it is again, chapter 8w covers every wire and fuse. totally, WK jeep, that be it. 8w page 63-8 see it, i do... cb 8, (circuit breaker 8) in the JB. http://www.morris4x4center.com/knowledge-base/index.htm?utm_source=cj#service

The first indication of a bad cooling/radiator fan is that is not turning. Or equally, that the vehicle temperature gauge indicates that the engine is getting hotter than normal. A noise from the fan may indicate that there is a bad bearing in the fan. If the fan is not turning it may not be the fan itself, but the fan relay or thermostatic controlled electrical switch could be bad. To check the fan itself, a jumper wire can be run from the battery to the battery. To attempt it, disconnect the fan plug which should have two wires, and attach the positive wire from the battery to one contact point and a negative (ground) wire to the other contact point. If the fan turns on, then the fan itself may be good.

Don't know engine size? I looked at info for the 4.7L engine, . Ect, It should be close to front of intake manifold. Two wire connector, wire colors, violet with orange tracer, dark blue with dark green tracer.

Radiator clogged? Water pump good? Radiator fan working?

Are you referring to the dash control panel?