20 Most Recent 1996 Oldsmobile Bravada Questions & Answers

These are on fuse #2
right and left lighted vanity mirrors in the visors check at the hinge you can pull the wires out far enough to unplug them. Then install fuse if it doesn't blow plug them in 1 at a time
depending on exact model the dome and rear light may also be on this fuse. I hope this helps. Take care.

1996 Oldsmobile... | Answered on Jul 11, 2019

Behind left hand side of instrument panel. Didn't see a picture, only text info. relay center, check above the interior fuse box.

1996 Oldsmobile... | Answered on Jul 11, 2019

Check the oil level again - you may have a leak. Running the transmission low on oil can damage one of the internal oil pumps resulting in a lot of problems like this.

1996 Oldsmobile... | Answered on Jan 04, 2018

Hello, I've had this problem before. On drivers side under the hood back near the brake booster, under the top of the fender fold. Look there, there may be a tiny hose disconnected from the nipple. Use your fingers to find the nipple, seems to be a common problem. Now, with the car not heating, what do you mean? Temp never gets up or the vents are not blowing heat? 2 different problems.

1996 Oldsmobile... | Answered on Dec 11, 2017

You are going to have to register on BBB INDUSTRIES
FREE Documentation site...

because... These are REAL GM drawings &
Technical Service Bulletins... (TSBs).

Get onto your SIGNAL/BRAKE Schematic Drawing
and figure out where your "SHORT" (cross-over) is

This is where the REAL technicians use tone tracers...
and open circuits to halves (50, 50) to isolate FAULTED CIRCUITS.

If you don't "open" the circuits... the tone will travel
everywhere... or no where.

1996 OLDSMOBILE BRAVADA 4 3L V6 Turn Signal Switch RockAuto

1996 OLDSMOBILE BRAVADA 4 3L V6 Turn Signal Switch RockAuto 1996 OLDSMOBILE BRAVADA 4 3L V6 Turn Signal Switch RockAuto

1996 Oldsmobile... | Answered on Mar 19, 2017

Probably transmission cooler lines. Could be engine oil cooler lines. Been a while since I seen one of these. They do go to the radiator or cooler in front of the radiator. You'll have to crawl under it and see where the go. Transmission or oil filter. Neither is a fun job. I definitely wouldn't do this on the ground. You can not cut the lines to get them out. You need to watch how you get them out. One first then the next. They have to go back the same way. Most older ones come out threw the back. You have to twist and turn them to get them out and in(pay attention to this also). You can bend the lines some, Just don't be extreme with it.

1996 Oldsmobile... | Answered on Jul 21, 2016

If you have burned or melted wiring, you need to fix that, first. Otherwise you might get an engine fire started and burn down the vehicle. I'd disconnect the battery till you get the wiring fixed.

1996 Oldsmobile... | Answered on Dec 02, 2015

The O2 sensor bank one sensor three should be the sensor after the catalytic converter.
Remember trouble codes only tell the mechanic what to test, not what to replace.

1996 Oldsmobile... | Answered on Apr 09, 2015

DIY? you will need a repair manual later anyway. Try your library, Your auto parts store should carry the manual, or try filepeep.com or manualslib.com. It should be near the fuel tank fill access, or nearby, perhaps close to the tank.
Or google images. you may find a picture and location.

1996 Oldsmobile... | Answered on Mar 27, 2015

Should be on the driver side near the rear axle.
Its usually right under the rear door.

1996 Oldsmobile... | Answered on Mar 26, 2015

Need more info , does it crank over or no ? If it does crank over an it doesn't start, check for spark at spark plugs an check for fuel pressure ! No Crank No Start Diagnosis EricTheCarGuy No Start Diagnostic Basics EricTheCarGuy

1996 Oldsmobile... | Answered on Feb 13, 2015

If it isn't on the left side of the engine, it is on the left side of the engine compartment nearest the headlight on an extenal adapter. This is not uncommon for some of these to have this.

1996 Oldsmobile... | Answered on Aug 04, 2014

check for powers and grounds at the injectors. if none of these then check wiring from injectors back to the pcm. if this is good you may need a pcm(computer)

1996 Oldsmobile... | Answered on Jul 18, 2014

Not finding what you are looking for?
1996 Oldsmobile Bravada Logo

192 questions posted

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts


Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Bravada Oldsmobile

  • Bravada Oldsmobile

Most Popular Question

fuse number 2 in olds bravada 1996

  • Cars & Trucks