20 Most Recent 1998 Nissan Maxima - Page 7 Questions & Answers

Here's your fuel system diagram,check for leaks,crank up and watch and look for gas stains at connections.Check cannister's filter.

Well you could use a real torque wrench, but generally you tighten the plugs with one hand or both to get the desired affect.18ft lbs is about the same as what you would use on any regular bolt.

Now you do,here's a link on how to replace your struts.

suspect
1 fuel managment may need reset to deal with changes.
2. new sensor is defective.
3. change of fuel filter and system cleaner may have disloged dirt into your fuel injection

Is the wheel turned one way or the other? if so you need to try to turn the steering wheel back and forth.It will not be easy.You may have better luck if you jack both front wheels off the ground then try to turn the steering wheel.

there is code table here: code table hope it can help u and good luck

IT MAYBE THE IGNITION SWITCH OR AWIRING PROBLEM. IT'S A PROCESS OF ELIMINATON, RUN IT DOWN. A READER MIGHT HELP YOU WITH THIS.

Do a video of your engine and show where the vacuum line is and around.

Here's the estimate,it uses a timing gear kit.Dealer cost is1820.00,10.2 hours,rate 100.00 per hour,labor 1020.00,parts 8.00 Shop cost is,1510.00,10.2 hours,rate 84 per hour,labor 856,parts 654.00 Do it yourself is,520.98 total.Prices will vary in different ares.

check the temperature sender for your fuel and emissions (not same as sender for gauge is most cases) if fuel injected, if carburated check choke. also ensure plugs and wires are in good shape

That cThat code has something to do with you EVAP system. It could be that there is a wire disconnected or correded which would normally be called a open/closed circuit. Other problem causes could be that your EVAP canister control solenoid valve or the EVAP canister itself are bad and they need to be replace.

EGR valve.

Blower motor resister is bad.Easy to remove,it's located by blower motor,click here to see what it looks like.

The warning light is on because the computer found a problem that will affect engine performance and emissions.You would need to get the computer scanned for trouble codes to proceed. Most auto parts stores will scan for free.

depends where you buy it.