20 Most Recent 2004 Ford Escape Questions & Answers

Remove the manifold and send it out to a machine shop, they can remove repair this broken bolt. Cost about $50.00

2004 Ford Escape | Answered on Oct 11, 2020

Some fixya user told me a website reliable-store it is very good.. I used it to repair my shredder it had some spark issue which wasn't easily fixed. you can go there and try

2004 Ford Escape | Answered on Mar 14, 2019

Remove the steering column shroud. Insert key into cylinder. Turn to ON position. Use a small pick to push up on the lock cylinder release button located directly under the cylinder. Then pull the entire cylinder out.

2004 Ford Escape | Answered on Feb 16, 2019

Keyless entry systems on Ford vehicles allow you to control a number of different security and convenience features. With your Securilock system, you can unlock your doors without fumbling with your keys, sound the panic alarm in a dark street or parking lot and pop the trunk with your hands full. You can set or reset the remotes from your driver's seat in a few easy minutes with no professional equipment or experience.
Enter your vehicle with your ignition key and remote and insert your key into the ignition.
Turn the ignition key from "Off" to "Run" eight times in the first 10 seconds, and end the eighth turn in the "Run" position.
Wait for the locks to click after the eighth cycle and press and hold any button on your remote within 30 seconds.
Hold the button for up to 30 seconds until the locks automatically click again, and this will indicate successful reprogramming. You can then remove the key from the ignition to end the process.

2004 Ford Escape | Answered on Jan 18, 2019

Vehicles equipped with the PASS-KEY or VATS anti-theft system usually require the system be reset whenever the battery is drained or replaced. Follow this procedure.
Step 1 - Attempt to start the vehicle. It will crank, but not run. The security light will be flashing on and off. Leave the key in the run/on position for exactly 10 minutes, then the security light will stay solid or go off.
Step 2 - Turn the key to the 'off' position for 10 seconds. Attempt to start the vehicle. Some vehicles will run at this point, although many will require you repeat repeat Step 1 two more times. Make sure turn the key to the 'off' position for 10 seconds before each 10 minute cycle.
Step 3 - The vehicle is now ready to relearn the proper code. Turn the key 'off' for 10 seconds and then 'crank' the vehicle. It should be running now. The security light might stay on solid for several minutes afterwards, depending on your system.

2004 Ford Escape | Answered on Nov 26, 2018

u must pull the radio out and remove the top cover of the radio, under that u will find a tiny bulb socket just behind the display inside the radio, remove that twist in bulb socket and replace the miniature bulb, any parts store will have it.

2004 Ford Escape | Answered on May 23, 2018

Headlamp relay possibly . location - under hood fuse box . Top left corner of the fuse box , I'm guessing . Don't know how this is situated in the engine bay .

2004 Ford Escape | Answered on Feb 20, 2018

Follow your coil wires back to the connectors for the ECM the wire could be corroded from cutting insulation to check previously or the coils connector check for continuity of the wires all the way back to the ecm

2004 Ford Escape | Answered on Feb 12, 2018

Clogged catalytic converter maybe .

2004 Ford Escape | Answered on Nov 12, 2017

That would be a lean condition or a clogged catalytic converter.

2004 Ford Escape | Answered on Oct 06, 2017

There are fuses and relays for both high and low beam.

2004 Ford Escape | Answered on Sep 22, 2017

Replace the engine mounts to lessen this issue.

2004 Ford Escape | Answered on Jun 27, 2017

Have you tried lots of different CD's?? If so and still same I suspect CD player faulty.

2004 Ford Escape | Answered on Jun 16, 2017

Wen you put back the battery on i think that you mist a groud wire that was on your groud cable or a power wire +try this and good luck

2004 Ford Escape | Answered on Apr 15, 2017

Bleed the cooling system it has trapped air.

2004 Ford Escape | Answered on Apr 08, 2017

Replace the vacuum hose in question, it has been damaged by oil intrusion.

2004 Ford Escape | Answered on Apr 05, 2017

Not finding what you are looking for?
2004 Ford Escape Logo

884 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

2002 Ford Escape
2002 Ford Escape

1,131 Questions

2001 Ford Escape
2001 Ford Escape

1,082 Questions

2005 Ford Escape
2005 Ford Escape

1,099 Questions

2003 Ford Escape
2003 Ford Escape

900 Questions

2006 Ford Escape
2006 Ford Escape

485 Questions

Top Ford Experts


Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Escape Ford

  • Escape Ford

Most Popular Question

04 escape wiper relay location

  • Cars & Trucks