1992 Buick Skylark - Answered Questions & Fixed issues

42.08 ounces (16 Oz in 1 lb) best to use appropriate gauges as overcharging will damage the system.

Probably the water pump, when the engine is completely cool, open the radiator cap, start the engine, turn on the heat full, and check to see if you have circulation at the radiator cap nosal you should see movement of water if pump is good....

Is the water pump working ? Is the cooling fan coming on at 225 degrees ?

power for the a/c unit comes via a switch,blower switch,climate control module, low/high pressure switches, fuses.

Did you check for spark at a spark plug ? If there is spark , spray carburetor cleaner in the intake an see if it try's to start , if it try's to start you probably need a fuel pump ! If no spark you have a bad crankshaft position sensor or ignition control module is bad.

The hose clamp may just need tightning.

nee to remove gas tank

On the internet Buick OBD 1 code 26 Replaced a tested & failed sensor? You don't replace good parts for no reason

Here it is.

165432

You have 2 issues here #1 the engine is running hot . Test the cooling system fans they seem to be not working. #2 car dies i would start with testing the secondary ignition (spark).

check the level as too much will show as air bubbles on dip stick

remove the inside door trim and inside the door cavity the window guide will be adjustable . probably from a nut on the inside door panel. Wind the window right up and pull the bottom of the guide back and tighten the nut. Wind the window up and down until you get the adjustment right.

if it was running when you parked it it should crank at least make sure the battery is hot for sure check your cables and tryturning the engine by hand

need help to fix it

if youve got the bolts out, the gasket may have it stuck on there, dont b afraid to take a rubber mallet and give it some encouragement, dont beat the hell out of it, just tap

What about this?

you may try replacing the computer,i had the same problem with my buick last year. a new computer solved the problem.

• these is because of timing ****** is one of the reason
• more carbon deposits inside mani-folds
• leakages in fuel injectors
• low pressure injector

tyr these first

Brake line routing diagrams (this is what I'd assume you are asking for) are not provided in the service manual in any kind of a real world diagram.