20 Most Recent 1995 Ford Econoline - Page 9 Questions & Answers

Near the tire where you are going to jack it up, you shoud see a long rail running the length of the van. This is the frame of the van. Along this frame near the tire where yo are going to jack up you will see a jack point. Use a flashlight to locate this. The jack point will be reinfroced and is designed to keep the jack from slipping. Thanks for using Fixya.

I doubt the manual would help on this issue. FIRST, be certain it is the rear main seal. EVERYTHING that leaks winds up there...Way more common is intake and valve cover leaks, and they drip at rear main area...

If rear main is the issue, you have to pull the trans for access.

Check fuse under hood usaly on drivers side. If not check relay you can swap relay temp for test only relay about ten bucks.

may need knew coolant temp sensor, if that doesn't fix your problem there may be a problem with the gauge in your instrument cluster

you may want to replace the fuel filter and run a fuel injection and fuel system cleaner .

For 1995 Ford Truck E150 1/2 ton Van 5.8L EFI 8cyl the Fuel Filter is located under vehicle, driver side, below seating area, mounted on frame in fuel line.

Hope helps (remember comment and rated this).

ya probably have it runnin by now but filter has to prime run the key on and off a few times not quick on then wait for the pump to kick off on and so on bout three times other wise look on the ground for a leak

The transmission has a problem with its shift points and likely it's due to the solenoids in the engine being defective or clogged with clutch dust from wear and tear.

Check the level of transmission fluid to make sure it's high enough, and filled to the top.

fuel injectors dirty?

under dashboard if not on the side...nomally hinden behind a lil door...if not...try under the hood

if it is on the rear of the engine on top of a tube assy it is a check valve for the emissions air pump

*Sigh* Though you have not asked a technical question I feel your pain. I stay away from Ford as their quality is not on par with some of the other big name manufacturers. My 05 F-350 had exterior emblems falling off and broken door panels from the factory.. Lame.

Should be near the thermostat

Hi,

Yes they will fit, but the gear ration maybe different.

Hope this helps

Jason

Yes you do, The first clips you removed are the secondary clips. The lines have to be released from the inside. Heres the info.. Cobra :-)
Removal

1. Open safety clip.
   
   
   
   

1. Fit Tool T90T-9550-B (5/16 inch) or T90T-9550-C (3/8 inch) to coupling so that tool can enter female fitting.
   
   
   
   

1. Push the tool into female fitting to release the retaining fingers from the formed male tube end.

1. Pull male and female fittings apart.
   
   
   
   

1. Remove the tool from the disconnected fitting.

1. Inspect the fitting for any internal parts that may have been damaged. Fuel tube should be replaced if internal parts are damaged.

at the end of the upper radiator hose.

start with your right foot.the accelerator pedal,attached to the throttle cable.attached to the throttle body attached to a butterfly valve inside the throttle body(of a carburettor)it is a tube of say 2"slimming down to 1.1/2" widening to 2"with the thinest part housing a fuel jet,and it is this tunnel effect that causes a rapid flow of air that mixes fuel in the inlet manifold.attached to the cylinder head etcetera
any help?

Without being hurtful. Reading your story,I would suggest taking your vehicle to a repair shop and leaving all your issues in the hands of the folks that take care of those issues every day.