20 Most Recent 1985 Ford Crown Victoria Questions & Answers


Local Ford dealership service department provide answer on location of the fuse panel. Fuse panel is located directly under the steering column. The cover panel is held by two screws and the power antenna swithch locking ring must be removed.

thank you all for you assistance,

1985 Ford Crown... | Answered on Jun 03, 2019


Here is a video link to removing the Air injection pump (AKA Smog Pump). As far as tools go you will need a full set of standard hand tools. Smog pump delete Ford 302 5 0 Crown Victoria LTD

1985 Ford Crown... | Answered on Jun 16, 2017


Sounds like one of the fancy heaters. They have circuit boards that can go bad. don-ohio

1985 Ford Crown... | Answered on Apr 14, 2017


From your description it could be fuel or ignition. Ignition is usually easier to start with and only checking the spark power and quality as the engine dies will indicate what is happening - if anything.

1985 Ford Crown... | Answered on Mar 18, 2017


The short answer is yes.
You would probably have to remove the pump in the tank to keep from trying to pull fuel thru it with the external pump. On some Ford models in the 1980s two pumps were used, one in the tank and one on the frame.

1985 Ford Crown... | Answered on Mar 22, 2016


Howdie You tube it fast easy if not ther DEALER

1985 Ford Crown... | Answered on Jan 18, 2015


Intake manifold clogged or blocked off?

1985 Ford Crown... | Answered on Dec 02, 2014


You will only get fuel at the injectors when cranking, the pump wont run(Usually) with just the key on. This is to prevent the pump running in a crash and feeding the engine.

1985 Ford Crown... | Answered on Jun 05, 2014


Dependent on what year you have. If it has an idle speed motor that could be cleaned as well as the throttle body. Idle speed motor may need to be replaced sometimes a good cleaning hooks them right up.

1985 Ford Crown... | Answered on May 08, 2014


Do you have the power window lock out switch turned on by mistake in the drivers switch panel?

1985 Ford Crown... | Answered on May 08, 2013


is it getting gass if u got spark to the plug's it should start.dump alittle gas down carb or throttle body making sure to replace air cleaner or snorkle and try and start.if starts could be fuel pump.

1985 Ford Crown... | Answered on Mar 03, 2013


Unscrew the wing nut on your air breather and lift it off. On the driver side of the car, on the side of the throttle body there is a bar/linkage that comes up from the side of the transmission that is supposed to be connected to the throttle body by a small plastic bushing/grommet fastener. As they age, they break off and will cause this delayed shifting. If you drive it hard enough it will eventually shift (35-40 mph) out of first gear. Probably wont shift out of second until closer to 65-70 mph. Same thing happened to me. I thought geeze this thing is not going to shift but it will. Should be a simple fix.

1985 Ford Crown... | Answered on Feb 02, 2013


Unless you are low on fluid, I suspect you are in need of a rebuild. I have had similar problems before. Any shop will tell you to try a fluid and filter change. It has never brought one of mine back. I would suggest adding fluid to the top of the 'add fluid' area of the dipstick and no more. It can foam if it is to full, causing similar problems as being to low. I would add that if you have to replace the transmission - you need to consider that the car may not be worth the cost.
Good Luck.

1985 Ford Crown... | Answered on Jan 31, 2013

Not finding what you are looking for?
Cars & Trucks Logo

91 questions posted

Ask a Question

Usually answered in minutes!

Top Ford Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14850 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Crown Victoria Ford

  • Crown Victoria Ford

Most Popular Question

broken lower ball joint need

  • Cars & Trucks
Loading...