20 Most Recent 1984 Ford LTD - Page 4 Questions & Answers

Remove the steering wheel to get at the directional switch,
you need to replace

Need a steering wheel puller

check your left side bulbs probably one that has a dual filament in the rear of your car

check the spark plugs, if its not firing on a cylinder your going to see fuel fouled plugs,

Need make, year, model and engine size ??

It may be possible, but difficult and expensive, to replace. Personally, I would get a dash mat instead.

You don't say what year this is. If it's less than five years old, the dealer should be able to order these. If it is 5-10 years old, maybe they are still available, maybe not.

Older than that, search the internet. Sometimes companies like Year One will have these.

Your other option is to go to an auto upholstery shop and ask them what they can do.

That sounds right. If that is not functioning correctly that would be a pretty good bet, usually there is nothing else that could or would be wrong

what year its the car or truck? try turning them around clock wise some calioper work like that in some cars like onda cars you migth need the tool that come to do this kind of caliper work .you can tell by looking at the serface of the caliper cilinder.

Yes it won't run unless all the plug leads are all installed in the right order and connected firmly.

It is located under the dash to the left of the steering column, you will need to get on your knees to see it.

it is located under the dash on the drivers side some are mounted near the firewall some you have to look up to see.

If you are sitting in the car or truck and you have a 290. The Drivers side is 5678 Passengers side is 1234 1 and 5 4 and 2 6 and 3 and 7 and 8

the fuel pump is control with a fuel pump relay if the system has fuel injection.a fuel pump relay turns on for 3to 5 seconds and turns off unles the engine is running.Older Ford models also have a fuel cutoff if the car is in a collision . but if you slam the door or hit a bump it will also cutoff. the switch is black with a white button on top of it and I think it is located under dash on passenger side ,behind the kick panel close to the door..if you push on button and
it clicks you have found the problem.Otherwise I would suspect fuel pump inside fuel tank.If thats the case sometimes you can tap on the tank a few times and make that part work.good luck

As you mentioned that seat go backwards properly,so seat motor is working.If there is power to the switch and it is acting erratically, the problem must be in the switch.
Remove the switch and replace it. Going backwards, the motor "works with" you, and current drawn by motor is less, but going forward, the motor "works against" you, current draw is higher, which always burns up the forward switch contacts faster than the backward switch contacts.Remove the seat and check the wirings.In the switch many a times wires get cut in between.You will have to check for 12 volt.The switch gets power to function from battery.If there is no 12 volt switch is faulty,check for short in wires,in some cases getting the wires reconnected helps.____________ And for the fuse which you asked,yes there is a fuse in power distribution fuse box under the hood.But if other function for seat are working then its not fuse,its faulty switch.------------ This will help.Thanks.Helpmech.

yes it can be your ignition module or ignition coil getin hot. most auto parts stores test ignition modules for free.