20 Most Recent 1992 Ford F350 Questions & Answers

1 Answer

I have a 1992 Ford

do you have acess to a scanner to see if park neutral switch is showing correct gear?

1992 Ford F350 | Answered on Jan 16, 2018

2 Answers

I have a ford F 350 diesel truck that the glow

Your distributer cap as a problem or a loose wire a plus and a minus wire 1 black and 1 red wire

1992 Ford F350 | Answered on Oct 23, 2017

1 Answer

Leaking front seal

replace the front seal in the transmission
overheating transmission oil is from
not enough oil
too much oil

1992 Ford F350 | Answered on Oct 21, 2017

1 Answer

1992 Ford F-350 5.8 l valve gasket

There should be some bolts surrounding the valve cover(s). Take them out take the valve cover off clean it up good put new gasket on put bolts back in tighten from center out so valve cover don't warp

1992 Ford F350 | Answered on Jul 29, 2017

1 Answer

95 Ford 460, replaced heads pushrods and lifters,

Trany operates off of engine vacuum, sounds like timing issues for the popping and cracking, more than one problem there.

1992 Ford F350 | Answered on May 24, 2017

0 Answers

1992 ford f350 diesel dually

1992 Ford F350 | Posted on Apr 27, 2017 | Be the first to answer

1 Answer

1992 Ford F350 7.3 Diesel, put in glow plug controller, controller clicks off and on but no power to glow plugs.

Maybe you got a bad glow plug controller ! Did you use a aftermarket part or OEM replacement ?

1992 Ford F350 | Answered on Dec 31, 2016

1 Answer

1992 Ford F350 - 7.3- 4 wheel drive. Light on dash says water in fuel and fuel filter. I changed fuel filter, did not help, changed fuel pump, checked fuel and there is no water.

The built in pressure relief valve in the fuel pump may be defective in the fuel tank, this causes fuel pressure to bleed off and causes hard starting..

1992 Ford F350 | Answered on Nov 03, 2016

1 Answer

1992 F350-7.3 4wheel drive is hard to start after changing fuel filter and fuel pump. Why is it hard to start?

indicates fuel leak back and fuel pressure drop
check filter installation for seal not sitting properly, loose fuel line fitting , pump installed correctly (flow wise ), filter installed correctly (flow wise)
air getting in to fuel lines
the thing you are looking for is indicated by the initial hard start but when started runs ok ( good fuel to the engine eventually) and then by the fact that if the engine is allowed to sit for a long period the problem returns meaning that the fuel pressure is not being held
could even be a problem fuel pressure regulator allowing the fuel to bypass ( no pressure =hard starting) then gets enough pressure to run ok but allows that pressure to drain off over time

1992 Ford F350 | Answered on Oct 29, 2016

0 Answers