20 Most Recent 1991 Ford LTD Country Squire Questions & Answers

Hello I have a problem with

Remove the starter and test it by applying power directly from the battery using jumper cables. If it doesn't spin, replace or rebuild the starter.

1991 Ford LTD... | Answered on Jul 02, 2017

1 Answer

Temp gauge not working 1991 ltd crown vic

Find temp. sending unit on engine. If one wire type ground that wire to good engine ground, with key on gauge should go all the way to hot. If it does replace faulty sender. If it doesn't than you have bad gauge, wire or connection. ( If replacing sender, make sure engine is cold. remove radiator cap to releave pressure and you will loose antifreeze when it comes out install new one quickly and don't use teflon tape as this needs to be able to ground to engine.)

1991 Ford LTD... | Answered on May 23, 2015

0 Answers

1991 ford ltd country squire premium sound wire colors

1991 Ford LTD... | Posted on Dec 23, 2012 | Be the first to answer

1 Answer

1991 ford country squire wagon... Reinstalling

just snug the nut up but not so tight the rotor will not turn. just snug enough so the rotor turns without being loose. have a good one!!

1991 Ford LTD... | Answered on Nov 22, 2010

1 Answer

What is the water pump attact to

The front of the engine. Look where the radiator hoses are connected.

1991 Ford LTD... | Answered on Nov 20, 2010

1 Answer

No indicator lights working all fusses and bulbs

Did you change the flasher relay? Do the 4 ways work?

1991 Ford LTD... | Answered on Jun 07, 2009

1 Answer

I need a stereo wiring diagram

you can just buy a addapter plug

1991 Ford LTD... | Answered on May 16, 2009

2 Answers

1991 country squire cranks but shuts off when put in gear

Don't remember for sure but I think that has a transmitttion with a lock-up converter. AOD trans I think. If so the converter is in the locked-up mode. Not letting it free wheel when put in gear. Will need to take it to a transmittion shop or dealership to have it checked out. Might be just a sensor or maybe a converter that's bad. Should get an amber check eng light too. Being that the lock-up is computer controled.

1991 Ford LTD... | Answered on Feb 08, 2009

0 Answers

I have a 1988 Ford Ltd Crown VIc and the heater motor speed fluctuates according to the motors RPMS. Is this related to the vacuum system?

Ford LTD Cars &... | Posted 7 hours ago | Be the first to answer

0 Answers

How to install a headliner

Ford LTD Cars &... | Posted on Jun 30, 2018 | Be the first to answer

0 Answers

Hola, tengo un motor ford 351, en lo que es el

Ford LTD Cars &... | Posted on Nov 27, 2017 | Be the first to answer

1 Answer

How do i change my blower out my 1976 ford ltd

The blower can be located under the passenger side dash or under the hood on the passenger side firewall. Remove the screws and electrical connector to the blower motor and it will come out.

Ford LTD Cars &... | Answered on Jun 08, 2015

1 Answer

My 1974 ford ltd has a problem staying running in the morning

check for an automatic choke setting. It should hang up on the throttle linkage until the unit gets hot and unwinds the choke butterfly off.

Ford LTD Cars &... | Answered on Mar 19, 2015

0 Answers

Diagram for serpentine belt route for london taxi tx2 2.4 2006

Ford LTD Cars &... | Posted on Oct 07, 2014 | Be the first to answer

1 Answer

How to replace the blower motor in 73 ford ltd

By now the blower motor should have been replaced a few times so hopefully it will be less hard. Disconnect the orange power wire at the rear of the right hood hinge and the black ground from the upper cowl. Remove the right front tire and wheel assembly. There should be an access panel in the fender. Remove it and you should see your blower motor. Remove the 4 motor mounting screws and disconnect the cooler tube from the motor. slide the motor and wheel assemby out the acess hole.
Hope this helps.

Ford LTD Cars &... | Answered on Jan 19, 2014

0 Answers