Top 20
1998 Dodge Ram 1500 4WD Questions & Answers
1998 Dodge Ram 1500 5.2L V8 M/T 4x4 truck won't move unless it's in 4th gear?
EVER SEE IT SHIFT RIGHT BEFORE, OR JUST BOUGHT A DEAD TRUCK? (HISTORY MATTERS)5.9L V8 (CLUTCH BAD) day, clear as day today. NV4500 OR NV3500 BOX SURE. ok revised today with magic words M/T the MC and slave must be bled fully and is not easy to do. the lines are Vertical and as you bled (actions) the fluid goes down and bubbles float up, and the job fails.! but this cases Clutch lockup failure or DRAG.not slip. (but put the here for others with NV4500) in the factory they used pressure bleed at the MC cap. fast and sure, but at home, DIY it can be very hard to get air out of this slave.CAUSE 1: the other cause is MC installed wrong the rear if the MC connects to the pedal when the pedal is not touched by your foot the rod from pedal top to MC rear must be at clearance a gap so the MC piston can fully 100% retract or the MC can not ever pump fluid correctLY blocking the internal MC bore bypass port. and slave is stuck EXTENDED links.>fork >> throwout bearingTO cause 2 of slip? the disc fits on the splinned, tranny pilot shaftand and if the splines are a wreck all galled upwe clean that up, grind it smooth, or the clutch can slip. as the disc hub stalls on the spline.as left foot is raised.or wrong throwout used and it jams up too.MY GUESS IS bad shift gate bushing,<<< A $8 FIX.read on.
How do you reset the security system in a 98 dodge ram 1500 4×4?
you can get guide from many sites.. i know few
like reliable-store
error codes/ fault codes, wiring diagrams, schematic diagrams, torque specs, engine info, switches functioning, assemble, disassembly, complete refurbish, repair, installation every single thing is covered
within seconds u can get the access and it's totally illustrative complete
1998 dodge 5.9 cummins.... I
This is probably a good guess. Get a vaccum gauge and poke around. If it truly is no vaccum going into the cab, find a source and hook it up. See if that fixes the problem.
Doug
04 Dodge 4X4. Front end
possible worn suspension rubber mounts, worn tie rod ends
take it to a suspension specialist shop for a check of the front end
Not finding what you are looking for?