1987 Dodge Ram Wagon B250 - Page 7 - Answered Questions & Fixed issues

9ate light? What would that be? Are you sure it doesn't say "Gate"? That would be the rear lift gate. Bad switch which is hooked to the gate latch inside the tailgate.

Hope this helps

Dodge Cars &... | Answered on May 04, 2020 | 287 views

have vehicle scanned for the code --alo check and test for a failed or damaged abs sensor/circuit

Dodge Cars &... | Answered on May 01, 2020 | 25 views

By what you describe, the fan clutch needs replaced. Engine idles at normal RPM and the fan is turning slower or very little, replace the fan clutch.

Dodge Cars &... | Answered on May 01, 2020 | 30 views

if the replacement is second hand then check the flap of the egr to see if its loose on the shaft also gain access to the egr to see if a bolt or washer is maybe lodge inside.check the vacuum unit on the egr sometimes the washer or spring inside can cause a rattle.last idea i know on most vehicles it recommended to replace throttle body and egr together so inspect the shaft and plate of the throttle body

Dodge Cars &... | Answered on Apr 30, 2020 | 182 views


Dodge Cars &... | Answered on Apr 29, 2020 | 25 views

timing-skipped tooth on timing chain --fuel filter--egr--cat converter -throttle body --have scanned for a trouble code

Dodge Cars &... | Answered on Apr 25, 2020 | 24 views

Autodata technical data usually has pinout diagrams as does Haynes manuals (usually).

Dodge Cars &... | Answered on Apr 22, 2020 | 29 views

is the rear driveshaft still there?? sounds a bit odd to me. do you mean it wont move unless in 4wd? possible rear axle failure, missing driveshaft...yes people steal them

Dodge Cars &... | Answered on Apr 21, 2020 | 39 views

Remove the transmission pan and you will see it right there. Looks like picture below.

Dodge Cars &... | Answered on Apr 15, 2020 | 95 views

The Transmission Control Module is located inside the transmission at the rear of the case underneath the end cover. The Transmission Control Module is located in an E-Box in the plenum chamber on the driver-s side below the Engine Control Module (ECM).

Dodge Cars &... | Answered on Apr 07, 2020 | 37 views

Dodge Ram 1500 error code p1df3
P1DF3 Meaning
The Transmission Control Module (TCM) receives the status of the initialization state from the ESM on the Controller Area Network (CAN) bus while evaluating a counter in the TCM to determine if the initialization time is excessive.

Dodge Cars &... | Answered on Apr 07, 2020 | 67 views

If you are changing the filter in the transmission, you have to drop the transmission oil pan. IT is messy and requires a new gasket for the pan and a torque wrench that measure inch pounds to put the pan bolts back on.

Dodge Cars &... | Answered on Apr 05, 2020 | 41 views


Dodge Cars &... | Answered on Apr 04, 2020 | 44 views

any that pass your emissions regulations. after market or stock which cost a lot more

Dodge Cars &... | Answered on Apr 03, 2020 | 31 views

Not finding what you are looking for?
Cars & Trucks Logo

Popular Tags

49 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

2000 Dodge Caravan
2000 Dodge Caravan

2,243 Questions

1999 Dodge Durango
1999 Dodge Durango

-935 Questions

1999 Dodge Ram
1999 Dodge Ram

1,750 Questions

2000 Dodge Durango
2000 Dodge Durango

1,576 Questions

2005 Dodge Caravan
2005 Dodge Caravan

1,472 Questions

Top Dodge Experts


Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides