20 Most Recent
Questions & Answers
I HAVE A FORD F350 V10 [GAS] THAT WILL SHUT DOWN
Hi, have you tried swapping out the PCM power relay? You can borrow the washer relay to see if this will clear up the problem. If it doesn't we'll need to go thru standard no-start troubleshooting procedure. Check for sparks, fuel, etc. I can give you those instructions next if the relay swap doesn't fix you up.
I have a 1999 ford f-350 that sounds like its
Injector pump seals most likely.
If they have never been changed,CHANGE THEM NOW!
One is HARD to change,make sure they change that one too and not just the easy ones.
2nd most common leak there is the return fuel lines between the injectors.
That should do it.
F350 diesel cuts off while driving
The problem you have I believe it is the cam sensor.....Low coolant level will cause the same failure ...If coolant isn't touching sensor which is located in the coolant reservoir...when coolant sloshes up and down while driving it will cause this to happen intermittently..Or the coolant sensor is just faulty...If it was fuel related it shouldn't crank at all...The best thing to do is have a dealership scan the system for faults rather than use a cheap scanner."..You can also check to see if there are any recalls....Check wiring for loose connections..also sometimes the negative battery cable will definitely cause this...It will become loose and the vibration will make it happen..and contamination. .".So check battery cables,coolant sensor wiring,and wiring at cam sensor which is located at front of engine behind fan ...If all cables,wiring and coolant level are good take it and have it scanned...Also check oil level...Hope this helps...I would call dealer first and ask about cam sensor recalls..,Then make an appointment..If it is a recall they will take their time and do all money making jobs before yours ...I know because I work at a dealership...They don't make any money for recalls...Good luck...Brooks...
I have an 1999 ford
P0344 = cam position sensor error
P0603 = Internal control module keep alive memory error.
P1670 = communication error between PCM and IDM
P0562 = system voltage low
My guess is you probably have some wiring issues but it's hard to tell exactly where.
Not finding what you are looking for?