20 Most Recent
2004 Dodge Neon Questions & Answers
How do i bypass the anti-theft system on 2004 dodge neon
Here are some ways to bypass or reset the anti-theft system:
1. Insert the key into the ignition and try to start it up, it won't. Leave the key in the ON position for at least 10 minutes, you would notice that the security light blinks and goes away. Now, switch of the car, wait for five to ten seconds, and start.
2. With all doors and windows closed, put the car's key in the driver's side door to unlock it. Hold the key in the unlock position for at least 30 seconds; this tells the car that the right key is being used.
3. Disconnect both battery terminals for atleast two hours. Put the car key in the ON position and then connect both battery leads at the same time. Wait for 15 minutes, and the car should work fine.
Where is the heater motor fuse location 2004 dodge neon
Hi on the drivers side of the dashboard where the door shuts onto it has a gap that you can put your fingers into to pull the pannal off,on the back of the plastic pannal that you pull off has a diagram of the fuses. all the best.
I have a 2004 dodge neon 2.0 it shakes when the
You should check the engine mounts again. Make sure you have the motion dampeners on between the engine and the mounts. Basically it's the rubber spacer you should have put on between the two to dampen the vibration of the engine to the mount. At least thats what it sounds like to me.
Codes are: P0700
Moisture has gotten into some electrical connectors when the heater core was replaced. These electronic transmissions have speed sensors and electrical connectors that do not like moisture in them. disconnect any connectors that may have gotten wet. Blow them out with compressed air. Good luck.
I am getting a p2074 code off my obd11 reader for my 2004 dodge neon sxt 2.0 l engine and a fuse light on my dash is blinking.
Not sure what the fuse light means, but you can localize the vacuum leak by going around the intake manifold and plugging off any ports. For example, the purge line can be taken off. Put your finger over the port to see if the engine idles down. If yes, trace the purge line back to the solenoid valve to find the leak. Similarly, you can remove the brake booster line and plug that port. If plugging the ports does not bring the idle down, next check the gaskets. Try spraying some carb cleaner on the gaskets while ybe engine idles. If the speed changes, uou have a gasket leak.
The radio won't turn on in my 2004 dodge neon
Has any work been done under the dash. Sounds like you have wire grounded to radio or something else the fuse sends power to.
Maybe you could unhook hot wire to radio. if fuse blows again you know it is not the radio.
Not finding what you are looking for?