20 Most Recent
Questions & Answers
Does the compresser have a fuse. mine wont come on
There is an A/C compressor fuse, but chances are that your system is low on freon. You have a low pressure switch located in the suction side of the system, usually right around the accumulator, that only allows the compressor to run if it registers a certain amount of pressure in the system.
2003 Buick century ac issues.
There's only one evaporator core, so if you're getting cold on one side and not the other, then the blend door isn't working on the warm side. The actuator motor may be working but the door might not be moving.
How to change the rear lights on a 2003 Buick Century.
yes you will you will have to take side trims and sill panel off get a 10 mm ready and take the bolts out the tail liaghts should come out the license lamps have screws in them and if you looka t them but you should be able to twist bulbs and pull them out / Please rate my response thank you very much
How to replace the fuse block on 2003 buick century
I recently tried the DIY service and repair manuals from a website and it actually helped me repair transmission problem in my jcb 3cx site-master. It would'nt move forward or reverse, engine was good both solenoids
for forward and reverse worked, but still couldn't diagnose the problem.
I don't have much technical knowledge but I just followed it step-wise, and works perfect! got it from www.reliable-store.comAll the best
2003 Buick century reset button in fuse box what is it for
Using the RESET button
- Adjust all tire pressures to the recommended kPa/psi.
- Turn ON the ignition, with the engine OFF.
- Press and hold the red RESET button located in the passenger side instrument panel fuse block.
- The LOW TIRE indicator will flash 3 times, then turn off.
- Use the scan tool in order to clear the TPM DTC.
2003 Buick Century
I know there's a code where you can turn the key X number of times, or something like that ??????? No it can't , you need to take it to a qualified repair shop.
Dodge , chrysler , jeep vehicles you can turn the key on - off - on - off - on three times an they show a coded in the odometer section of the instrument cluster . GM vehicles you need to plug in a scan tool .
Your best bet , take it to a qualified repair shop.
Not finding what you are looking for?