20 Most Recent 1989 Chevrolet S-10 Blazer Questions & Answers


look in the owners manual for the vehicle. find the fuse diagram and it will indicate which fuse on fuse block is for cigarette lighter

1989 Chevrolet... | Answered on Jul 23, 2019


there is a seal right there you can side it back and put a new seal.

1989 Chevrolet... | Answered on Feb 04, 2018


The fuel injectors need voltage and ground. The voltage usually goes hot with key on and is fuse protected. When problem is ongoing, you could use a test light to check for voltage at fuel injector. Engine cranking if voltage on both wires, there is no ground. The computer grounds that circuit.
There is a purple wire with white tracer that carries rpm signal from ignition module to computer, that is rpm signal, w/o that dc pulse on that wire, the computer won't ground the fuel injector. Just my opinion. There could be a problem with your ignition module, but, I can't be certain?

1989 Chevrolet... | Answered on Sep 26, 2017


Smoke isn't a good thing. When you shut the engine off the engine actually heats up some prior to cooling down because the coolant isn't running through the engine any longer. When you have electric fans, that's why they stay on for a few minutes after the car has shut off. Is the smoke coming from the fuse panel on the fender well or could it be your valve cover gaskets leaking onto the exhaust manifolds?

1989 Chevrolet... | Answered on Jul 20, 2017


Chances are you have an oxygen sensor problem. When the engine warms up, the engine computer moves from open loop operation to closed loop, and it then uses the O2 sensor readings to adjust the fuel. If the sensor(s) is contaminated, it will send a false reading to the computer causing this problem.

1989 Chevrolet... | Answered on Mar 12, 2017


40 Oz of R-12 and 8 oz of mineral based refrigerant oil.

1989 Chevrolet... | Answered on Sep 21, 2016


you will need to have the oil pan on, its pretty tight when you put in a 350 ,also a 3" body lift will make things alot smoother godbless

1989 Chevrolet... | Answered on Jul 21, 2015


anywhere from starter to engine seized. i would think starter.

1989 Chevrolet... | Answered on May 04, 2015


one under the hood and one under drivers side dash

1989 Chevrolet... | Answered on Mar 30, 2015


the radio maybe

1989 Chevrolet... | Answered on Mar 24, 2015


Recheck your wiring, sounds like wiring ins't right to me....Maybe a cut or pinched wire some where....There is a chance the window motors are bad also...I hope you find the problem, my 96 would not roll back up after going down turned out to be the motor on drivers side was bad...Good Luck....

1989 Chevrolet... | Answered on Feb 28, 2015


Likely the great selector switch which is located on the side of your transmission is shot. Sometimes called a range switch. It turns on the gear lights on your dash P,R,N,3,2,1. But also puts your truck in the proper gear. Also engages other components in the ignition. Chech the connector plug for corrosion, if clean may be the switch is gone.

1989 Chevrolet... | Answered on Feb 24, 2015


They make special sockets for that problem at a local parts store..If Trans is still mounted to engine it will be a major task..You can remove TRANS with force just to get it out of the way because the torque converter will slide out of the trans and remain mounted to plate...This is dangerous and messy to do..DO NOT TRY UNLESS YOU HAVE ALL SAFETY EQUIPMENT..Also you need an assistant....Be sure TRANS is in neutral if you attempt this...

1989 Chevrolet... | Answered on Feb 21, 2015


Worn lock cylinder...replace

1989 Chevrolet... | Answered on Feb 03, 2015


If it is a 4x2, yes. If it is a 4x4, maybe. if same engine and tranny in both they will interchange on a good day. If not the same engine and tranny, 4x4 will probably not swap.

1989 Chevrolet... | Answered on Jan 12, 2015


Replace bulb first. Then check fuse.

1989 Chevrolet... | Answered on Jan 01, 2015


If you can hear the motor turning but window is not moving, then the window most likely came off it's track. You will have to remove screws and pry off the door panel and replace window on track

1989 Chevrolet... | Answered on Dec 15, 2014


This tripped the inertia switch that cuts off the fuel pump some are located behind the left kick panel others are on the bulk head near a shock tower or strut mount ,may be installed in the rear quarter panels also

1989 Chevrolet... | Answered on Sep 23, 2014

Not finding what you are looking for?
Cars & Trucks Logo

561 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Chevrolet Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Blazer Chevrolet

  • Blazer Chevrolet

Most Popular Question

1989 s 10 blazer put new window switches

  • Cars & Trucks
Loading...