20 Most Recent 1989 Chevrolet K1500 Questions & Answers

0helpful
1answer

1989 chevy silverado spark plug gap?5.7 k1500

Always use stock type plugs,that what there called for,some vehicles like yours don't run good on other types.They come set at factory,I always check gap and they are always right.As they say,it ain't broke don't fix it.
10/14/2021 1:14:31 AM • 1989 Chevrolet... • Answered on Oct 14, 2021
0helpful
1answer

Where is the vss located on a 1989 chevy k1500 ?

tailshaft of trans where driveshaft slides in
2/9/2019 10:45:24 AM • 1989 Chevrolet... • Answered on Feb 09, 2019
0helpful
1answer

1989 chevy have brake lights when park lights are off but when park lights are on have no brake lights pulled the light cover off noticed that the middle buld was on which is for stop, tail, an turn s

Check the brake light switch on the brake pedal. Sounds like it slipped out of adjustment. When pedal is depressed, the button on switch will extend and be on to pass current to the bulbs. Also, you need to figure out the tail lights: those two filament bulbs are for park lights and for brakes/turn signals. One filament is for the parks, the other filament is for both brake and turn signals. American cars have the brake lights wired through the turn signal switch- from the brake light switch on the brake pedal to the turn switch, and then out to the rear bulbs for brakes and, or turn signals.
2/11/2018 9:10:04 AM • 1989 Chevrolet... • Answered on Feb 11, 2018
0helpful
2answers

My 89 Chevy k1500 has the rpms but won't do over 35mph an boggs down an dies what could it be

The generic info for problems at higher rpms, check for a blockage of some kind, fuel--air--exhaust. How long since a tune-up? Any applicable trouble codes? It's not a tranny issue, correct?
11/7/2016 11:16:26 PM • 1989 Chevrolet... • Answered on Nov 07, 2016
0helpful
1answer

Can i use the wiring from 1989 chevy truck to change engine and tran. to 1965 truck

Yes you will need the computer and driveline harness make it work or you can get a painless wiring harness and eliminate the time it will take you to adapt the factory harnesses together
5/12/2016 6:50:09 AM • 1989 Chevrolet... • Answered on May 12, 2016
0helpful
1answer

Why does it sound like air escaping when brakes applied in my 1998 chev k2500?

Diaphragm in the brake booster has busted the sound you are hearing is vacuum from the engine escaping into the cab
5/12/2016 6:37:46 AM • 1989 Chevrolet... • Answered on May 12, 2016
0helpful
1answer

Rear whining when I let off the gas pedal. just had the rear diff pinion seal replaced. what could the whining be ?

Pinion gear needs to be adjusted OR bad bearings. Was this a USED unit? Check YouTube for a video titled "How to set up a pinion gear in a differential".
2/21/2016 3:05:19 PM • 1989 Chevrolet... • Answered on Feb 21, 2016
0helpful
1answer

What are the cylinder numbers chev v8

1,3,5,7... Driver side starting at front of engine,,, 2,4,6,8 pass side starting at the front
5/27/2015 8:59:17 AM • 1989 Chevrolet... • Answered on May 27, 2015
0helpful
1answer

I got everything a loose but the transmision wont move 89 chevy 1500 4x4

Its either Stuck on the alinement pins, or remove starter,,,,, also there are a couple of the bolts that have nuts holding on wires,,,remove the nuts and the bolts the nuts were on,,, with deep well socket,,,,,, there are also 3 torque converter bolts holding it to the flywheel that need to be unbolted,,, hope this helps
5/27/2015 8:43:20 AM • 1989 Chevrolet... • Answered on May 27, 2015
0helpful
2answers

1989 K1500 was running fine and just quit. Not

you need to have the fuel pressure checked with a gage and volume as if its not at the spec the injectors won`t open to spray enough fuel.also you should check the injectors for proper voltages and ground as if these are not within specs then the injectors won`t work either
5/5/2015 6:14:20 AM • 1989 Chevrolet... • Answered on May 05, 2015
0helpful
1answer

How do you adjust the gears in a chevy s1500 truck?

Easy to do there is a small bolt Under your dash near the steering cullum slack your bolt put it in park aling your gear red line to park and retite the bolt and job done...
4/24/2015 1:03:36 PM • 1989 Chevrolet... • Answered on Apr 24, 2015
0helpful
1answer

It runs okay for a few minutes then you have to keep one foot on the gas and one on the brake to keep it ri

You seem to have a very bad vacuum leak. Look at all your rubber hoses under hood , for cracked, loose , broken or missing hoses. You may even here them hissing. Replace any that you find. GOOD LUCK FRIEND.
12/4/2014 1:37:21 AM • 1989 Chevrolet... • Answered on Dec 04, 2014
0helpful
2answers

No power to the heater/ac control of our 89 chevy silverado

IF YOUR BLOWER MOTOR IS GOOD AND FUSE IS GOOD TO AC/HEAT THAN THE CONTROL BOARD IS NO GOOD
11/22/2014 1:52:50 AM • 1989 Chevrolet... • Answered on Nov 22, 2014
0helpful
1answer

Will a 1989 Chevy transfer case fit on a 1995-1999?

no,it won't.
11/2/2014 10:07:22 PM • 1989 Chevrolet... • Answered on Nov 02, 2014
0helpful
1answer

Chevy wont start

Are you lacking spark or fuel ?
7/30/2014 2:18:51 AM • 1989 Chevrolet... • Answered on Jul 30, 2014
0helpful
2answers

Chevy truck problems

Could be plug up catalytic converter,check fuel filter,
7/29/2014 2:06:24 AM • 1989 Chevrolet... • Answered on Jul 29, 2014
0answers
Not finding what you are looking for?
Cars & Trucks Logo

353 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Chevrolet Experts

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6929 Answers

john h

Level 3 Expert

25255 Answers

Ryan Lutton
Ryan Lutton

Level 3 Expert

1267 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

1500 Chevrolet

  • 1500 Chevrolet

Most Popular Question

89 chevy k1500 rpms but over 35mph boggs

  • Cars & Trucks
Loading...