20 Most Recent 2005 Chevrolet Trailblazer Ext - Page 7 Questions & Answers

Open the hatch. On the door jam at the light assembly there are two screws, these may be cover with a plug. Or they may be plugs them selves that hold in the assembly. I have seen both. remove them and pull the assembly out. the is a clip that holds in one side , so just pull a little harder to get it out.

Usually caused by the canceling switch in the wiper motor failing. The switch normally allows the wiper motor to operate after the wiper switch is turned off so that the wipers are in the down position when the motor shuts off; otherwise the wipers would stop in any position when you shut the switch off.

needs more gas ,vehicle with two AC units need around 1.2/1,5 kgs of gas to function

Switch relay #45 with relay #46 in the fuse box under the hood. Do you now have lights? If so, replace the relay. Very common problem.

What does it look like?

IT could also be a wiring. If you can swap this radio with another working one to test if the radio or the wiring is the issue to avoid buying a radio if the wiring is the issue.

check for power to the switch ,, before and after

I have the same exact problem - none of the controls work and neither cabin lights nor key-in-ignition chime works. I've checked fuses and modules at fuse/relay box. Cannot find cause.

Si no lo est? haciendo bastante fr?o r?pido, habla con el comerciante, no hab?a una soluci?n para esto hace a?os problema. Necesidad de comprobar el nivel de fre?n demasiado, puede ser que necesite algo. Si se trata de hacer ruidos, los rodamientos son malos, debe sustituir el compresor completo.

Remove the plastic resonator on the top of the engine and remove the air cleaner hoses.

You'll then see 6 coils. Remove the first one (2 screws) then carefully pull up and out on the coil. Then you can remove the plugs. Best plugs are A/C Delco 41-103. Hardest one to get to is #6 at the firewall, but with some extensions and knuckles, can be done.

What's the code that is on the print out that they should of given you? Should start with Pxxxx

Thanks for choosing FixYa and welcome to the site. In order to change your spark plugs, you will need a spark plug socket with an extension. You need the extension because the plugs are deep. Thanks for using FixYa. If you have any questions, feel free to ask.

WELL WE WILL START WITH YOUR FUEL GAUGE. WHEN IT QUIT WHERE IS THE HAND AT, IF ITS SHOWING OVER FULL THAT MEANS THERES A GROUND WIRE OFF SOMEWHERE. FRIST CHECK THE TOP OF THE TANK YOU WILL SEE ALL THE WIRES THERE, FIND THE ONE THATS PLUGED INTO THE SENDING UNIT, T SHOULD BE THE ONLY ONE THE REST ARE ALL RAPED UP. NOW FOR TH FAN, REPLACE IT, WHEN THEY DO THAT IT MEANS THE BUSHINGS ARE GOING. I HOPE THIS HELPS YOU OUT. PS THATS NOT GOOD WHAT THE DEALERS ARE DOING, BUT WHAT CAN YOU DO. JIMBO

Check the wiring/contacts that transfers power from the body to the rear door for a break or a bad connection. Check the switch as well in case that has gone faulty. It would not be a fuse, all the wipers work off the same fuse. Finally check the motor itself, but they seldom give problems.

Drivers side....stick your hand down by the alternator and over behind the back of the headlight assembly. You'll feel a 3" round rubber boot, just pull this off. Twist out the bulb and replace.

Passenger side...remove the air cleaner box, when this is done, you can remove the rubber boot and replace the bulb with plenty of room.

The other method involves removing the grill, but pulling this out can break the grill, it's brittle. So I choose not to do this method.

Hello: Open the rear door, you will find two screws on the inside on the side of the tail light, remove the screws pull back side forward to unhook the lenses assembly unplug it, remove board from lenses assembly. Re-install in reverse

Call the dealer and see if the brake light re-call is still active.

Hi!
Some cars are made that way when the oil pressure is low the car stalls to prevent damage to the engine, So you need to check the oil level ,If its good then check the pressure because it might be a bad oil pump. Good luck