2004 Chevrolet Venture Passanger - Page 6 - Answered Questions & Fixed issues

Could be either. Usually if the compressor is cycling than its usually low on refrigerant. Could be pressure sensor. Could be cooling fan. I would have a different tech look at it. It is hard to diagnose what is going on without knowing pressures of the high and low side from a gage hooked up to the system.

Yes ! The headlight is more than cracked,which is allowing moisture in. the sensor is not part of the headlight {dust to dawn operation}. If you replace headlight. You will have no problem with operation of lights.

Sometimes moisture can get into the connectors and short out the system giving it an error. Mine was in the passenger compartment under the seat. Sprayed it out, cleaned it up and light went out. I just kept up on the brake maintenance, fluid level, pad and rotors more so than average. In all honesty, the brakes received horrible marks in that vehicle's reviews. With the light on I took it to a shop because I have no ABS tools, they could not tell me what was wrong with the system other than the light was on.

Yes what doesnt show on the outside is loose contact on the inside

Sounds like your fuses are out... no power to the control panel? It sounds like you have a fuse problem. Try and check your fuses and connections.

Not sure about your particular model but most GM vehicles have a module on the wiper motor and if it fails it will cause your symptom and it is a common problem. You may have a bad wiper switch also. You would have to do some votage tests at the motor to eliminate the switch being bad.

This car uses a type 4T65E automatic transmission

I know that it may be hard to let go of a vehical, but sometimes a vehical gets to a point that it may just be easier to get a new vehical instead of worrying with this problem. This problem is not going to stop at $500 more than likely. I would recommend www.autotrader.com to buy and sell your vehical. I hope this helps. You could always keep repairing it as well, but I would go this route. Please rate 4 thumbs up!

There might be problems with the wiring. Have it inspected. It might be grounded. You may want to check the relay as well.

fuel filter is under the van on the inside of the frame, it may require special tool to unlock the fuel lines, its a round canister about 4 inches long .has a clamp and bolt holding it to frame. should be changed with every tune up.

This is a social chat room or web site,
not a repair shop or parts warehouse

Your problem is going to be the wiper resistor. It is located on the passenger side under the dash. Click this LINK to see what the resistor looks like.

CHECK THE FUSE,S SOME THEM ARE RELAY FUSE,S

BETWEEN THE BATTERY AND THE FRONT GRILL LOOK AND YOU SHOULD SEE A PLASTIC WEDGE WITH A BOLT IN THE CENTER REMOVE THE BOLT AND THE WEDGE AND THE BATTERY SHOULD COME OUT

Wath seal in wath place in engine?

From the dealer or a salvage yard

section it and use hose clamps. not muc pressure there.

http://groups.yahoo.com/group/villagerquest/

Failed seat heating elements are fairly common. I have also seen several failed seat control modules. Access to the data from the Body Control Module and the Seat Module is necessary to perform an effective diagnosis.

Here's a great video that will show you exactly hos to remove the headlights in your 97-05 Chevy Venture">

if you have the owners manual I think you can do it on the radio