20 Most Recent
- Page 2 Questions & Answers
How do I check brake switch wiring
those switches make continuity ( makes the circuit to the brake light ) when we brake our vehicle, then when brake pedal is not being pushed it disengages the circuit, therefore turning off break lights.
Use an ohmeter with no voltage applied to ciruit , check switch With switch engaged ( zero or about zero ohms ), switch disengaged should show infinity ( nothing on the ohmeter ).
on Sep 22, 2014
How many miles does it take for a service engine light to reset?
Nothing to do with miles
If the new sensor was the correct fix, then the light would be off
Maybe the light will go off when the Emissions Monitor Runs,
but doubt it,you went 4 miles & the O2 Data has to be working
You DO NOT Replace parts based on a code
Codes have nothing to do with parts
Codes only indicate an out of range parameter or possible fault
You use the codes to component test the system, that set them
Find a fault or problems
Make the repairs, if necessary
You had no diagnostic test
You had it checked for generic codes only
You have to component test all old & new parts,not
just hang them on there, because of some one is selling
parts with no vehicle knowledge
on Aug 18, 2014
Where is the fuse for a chevorlet Lumina 2001 taillight.
Fuse boxes located under dash.under hood.in a small plastic cover on left side kick panel on drivers side.should be marked lights or tail-lts. Is all lights on rear of vehicles out or just one side or part of one side as any lights work fuse is still good.brake lights also if they work fuse good.access bulbs from trunk remove 6 screws pull cover.remove wire plug push light socket in turn back counterclockwise.
on May 18, 2014
OBD-11 codes 0403 & 0405
code p0403 refers to EGR --circuit malfunction===causes ---wiring--EGR solenoid---ECM
code p0405 refers to EGR valve position sensor A --low input===causes ---wiring ---short to ground---EGRF valve position sensor--- ECM.
By only changing the EGR valve you have not fixed the problems that cause the valve not to work.
on Dec 22, 2013
while holding the up button-hit the inside of the door about in the middle-this may break the motor lose and you may get it to go up atleast until you can get a window regulator motor to replace it - cheers Denny
on Dec 07, 2013
Not finding what you are looking for?