Top 20 1998 Chevrolet C2500 Questions & Answers

Have a 1998 chevy c2500

Check the hot wire going to/at the distributor .. a number of these were crimped on the wires insulation/casing and not on the wire itself,,, it makes intermittent connection.
..This is hard to diagnose,, your symptoms are exactly what this causes... Good luck...

1998 Chevrolet... | 103 views | 0 helpful votes

I have a 1998 C2500 Chevy truck I replaced the horn fuse and all I get is a clicking sound from the horn relay. Should I replace it also? What else could be wrong?

There are some connectors behind your steering wheel that may be messed up. My 1999 chevy s10 had a dysfunctional horn I had to remove the airbag from the steering wheel to access the wiring harness to the horn and i had a broken wire that caused the horn not to work I replaced that and problem solved. Also Your actual horn is usually located in your front bumper and that may be damaged if it is replacing it will fix the problem. Hope this helps good luck

1998 Chevrolet... | 178 views | 0 helpful votes

Why I'am not getting spark to plugs?

Sounds like ignition module has failed or there is no power to the distributor.

1998 Chevrolet... | 32 views | 0 helpful votes

I have a 1998 2500 chevy 4l60e that was all the wires been strip off of it.. It is stuck in limp mode [I guess] all I need is 1st to move it around the farm.. Is there anyway I can wire it so it will

Give system voltage to the two shift solenoids. This will put the trans in 1st. The lever has to be in drive.

1998 Chevrolet... | 60 views | 1 helpful votes

Torque Settings - Cylinder Head

first 40nm, second time,60nm,and last step, 90degrees ,

1998 Chevrolet... | 418 views | 0 helpful votes

What is the tightening sequence and the torque settings for VW Caravelle 1998 2.6?

if you just put a head gasket on there it came with torque specs most do.. if not call the parts store..

1998 Chevrolet... | 277 views | 0 helpful votes

How to replace ignition switch on 1998 Chevrolet 2500

the steering wheel must be removed there is a pin to remove the tumbler.

1998 Chevrolet... | 1,180 views | 3 helpful votes

Fuel leaking from oil and water seperator canister

Hi Mike, Replace the seals or the unit. Regards John

1998 Chevrolet... | 40 views | 0 helpful votes

How do u know power booster is bad

That is normal to a degree. When a booster fails, the pedal is very hard to push and the engine can have a vac leak.

1998 Chevrolet... | 22 views | 0 helpful votes

How to replace horn on 1998 chevy c2500 pickup

You could always call a <a href="http://www.norrismechanical.com/hvac/">heating and ac company</a>. That could help.

1998 Chevrolet... | 215 views | 0 helpful votes

Temperature Switch need help to change

if it is a sbc 350 it is in drivers side head with a green wire going to it

1998 Chevrolet... | 89 views | 1 helpful votes

How many pitman and idler arms does a 1998

1 & 2

1998 Chevrolet... | 128 views | 3 helpful votes

Need spark plug gap

I plain site on almost all vehicles,
on the Federal Emissions Label
under ther hood or on the radiator
support

1998 Chevrolet... | 25 views | 0 helpful votes

I have a 1998 chevrolet

There is a sequence of tightening the head bolts in a specific order in 2 passes, the preferred method is to tighten all bolts to 22 ft lbs, then add 75 degrees turn to long bolts, 65 degrees to medium bolts, and 55 degrees to short bolts. If you need the picture go to a library and use alldata to print it out.

1998 Chevrolet... | 84 views | 0 helpful votes

Where do i look to check and fill transfer case

on the side of the 88 transfer case is a inspection bolt 15/16 by the front drive shaft if it is a new process 205 case. remove cap bolt and fill till lube comes out and its full

1998 Chevrolet... | 163 views | 0 helpful votes

When my truck is idleing it has a skip to it. i

This is usually caused by a bad valve or a bent pushrod. Either way at least one of the exhaust valves is not seating properly. You could pull the valve covers, remove the rocker arms, and pull each pushrod and check them one by one for straightness to eliminate the easy fix, but if you don't find a bent one you will have to pull the heads to check the valves. Personally I would pull the heads anyway and inspect them because a bent pushrod could be a symptom of a bigger problem.

1998 Chevrolet... | 98 views | 0 helpful votes

Just replaced heads,rockers,pushrods,spark

Only way the rockers won't move is if the cam isn't turning. Only way that can happen is if the timing chain isn't turning it. Go back inside and find out why.

1998 Chevrolet... | 84 views | 1 helpful votes

When i driving i have a problem, e.g i fill that

sounds like a oxygen sensor may have gone bad....causing bad readings to computer...run code reader check at auto parts store for free

1998 Chevrolet... | 38 views | 0 helpful votes

My rear brake shoes are locking up when the

moisture is getting in the shoes, You may need to just replace them with a better brand/ quality of shoe.

1998 Chevrolet... | 139 views | 0 helpful votes

Need to change the headlight

Here is the OEM part number and dealer price:
Part OEM Part Price Headlamp Bulb Sealed Beam 5972698 $33.52

1998 Chevrolet... | 125 views | 0 helpful votes

Not finding what you are looking for?

Popular Tags

114 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

1999 Chevrolet C2500

54 Questions

1994 Chevrolet C2500

42 Questions

1988 Chevrolet C2500

37 Questions

1995 Chevrolet C2500

36 Questions

1991 Chevrolet C2500

33 Questions

Check Out the Latest Top Trucks Report!

View all Fixya Reports

Top Chevrolet Experts

Marvin

Level 3 Expert

85239 Answers

john h

Level 3 Expert

23515 Answers

Joe Taylor

Level 3 Expert

2228 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Have a manual for 1998 Chevrolet C2500? Or just drag it here!

View Most Popular

C2500 Chevrolet

C2500 Chevrolet

Most Popular Question

1998 2500 chevy 4l60e all wires strip

Cars & Trucks

Loading...