20 Most Recent 1993 Chevrolet Sportvan Questions & Answers

Its most probably the fuse,they are under the dashboard or on the left side under the steering wheel.The use for the fuses is marked on the lid off the box

Your cooling fan should run until it brings the coolant temperature down to set limits. So if you hear the cooling fan running for several minutes after you shut off the engine, it could be that. But if it goes on for too long then it could be a problem.

lol everything but the actual cause of the problem. The big clue here is your gauges. What sensor going bad will cause the gauges to jump? Ask your mechanic that wasted all your money replacing good sensors. Then you may want to find a good mechanic. The problem is a wiring problem. Probably the main hotline running from the ignition to the fuse block. Somewhere in that area. If you have the spark circuit on a scope you would find it flat line when it hesitates.
I dont think it is a short because if it was you would have blown fuses or smoke and or electrical smell. So it has to be an open circuit that would be nearly impossible to find. If I was going to just start replacing things, I would start with the ignition switch and then the fuse block and then any hot wires to and from both elements.

If you go to www.2carpros.com they have should what you need. On the left side of the page just follow Belt Routing Diagrams.

check fuel injection system, might need cleaned or repaired

you don't need to look for the hinge pings at salvage yards you can find them brand new at the "HELP" section on must auto part stores
look on the shelves on the items of the HELP brand.
they come whit new brass bushings and your door will work like new.

check all your vacuum hoses and the throttle body itself for a vacuum leaks if the hoses replace as nessasary if to check for throttle body get can of carb cleaner and spray around base of throttle body and sides not in it if idle raises you have a vacuum leak goto a good parts store and ask for a rebuild kit don't goto auto zone or advance they don't carry them

EBAY......

When I need a diagram or info about my car I go to www.autozone.com You can register for free and get immediate access to repair and shop manuals for your vehicle.

go to walmart pay $5 for installation plus the cost of the bulb

Your turn signal switch is worn out or broken...this is located inside the steering column...on older cars (pre-airbag) you need to remove the steering wheel to gain switch out...This part is available for your car at most auto parts stores. Hope this helps.

Hello
Wiring diagram for Motor homes are only available from the company who performed the conversion, they are not in the factory service manuals. You will need to contact them if they are still in business and see if you can get the diagrams. Also you can call local RV repair centers and see if they have the diagrams in there archives. My advice is based on many years of RV repair with electrical problems being my primary job.

go to your local library and get on there on line data base computer and go to all data clicck on the link and select your veh and you can print of diagrams

Depending on what size your axle is.If you have bolts(6or8) at the very end of the hub.You remove all of the bolts the smack the end of the hub with a hammer to pop out the wedges in the stud holes.If there is just the shaft/plate with studs the you will need to remove the punkin cover and there will be a retainer bolt that holds a 1/2"-3/4" pin.When you get the pin to fall out you will be able to pull the axle shaft out to remove and replace the seal.

one of the bulbs has abroken filament and it connects to the other filament causin this concern replace lr brake light bulb and it will be fine

A turbo400 trans will bolt up but you will have to change the drive shaft as the output shaft is longer than the 350 trans. There will be no trans exchange with a different type that will fit without some modifications.