I HAVE A 2000 NISSAN NISSAN MAXIMA WITH ONLY 50 THOUSAND MILES ON IT.THERE IS NO CHECK ENGINE LIGHT ON.THE TRANSMISSION IS SLIPPING BUT IT IS NOT THE TRANSMISSION.I HAVE ALREADY CHANGED THE CYLINOIDS AND THAT WAS NOT THE PROBLEM.WHEN I TURN THE CAR OFF,AND START IT UP AGAIN,SOMETHING RESETS,AND THE CAR SHIFTS FINE.
Posted by bornn22sur... on
If you havent already try to change the transmission filter.Sometimes when the filter gets dirty fluid pressure is comprimised and certain pumps and solenoids which control shifting inside the transmission function off of the fluid pressure,
Posted on Apr 12, 2009
where is crank sensor located on nissan maxima 3.0
Posted by Annastacia... on
crank sensor is at the bottom of the crank pulley. right under neith the pulley is a 2 wire sensor bolted to the engine with 2 bolts.
Posted on Sep 18, 2012
I can't figure out how to remove the housing that covers the seatbelt without damaging it. Can you help
Posted by msgt on
Posted on Nov 03, 2008
are these sensor ?
Posted by gman40 on
P0420 and P0430 are codes related to the catalytic converter effeciency. The catalyst will need to be replaced $$.
Posted on Nov 26, 2008
I have a 2000 Nissan Maxima and about a month ago my brake and battery light went on. Needless to say, the next day my battery died which was due anyway. So I bought a brand new battery (DIE-HARD) and when I left the lights went on again. I mentioned it to the very young new mechanic and his response was that this was common, take it on the freeway for a while and it should clear up. Absurd but it worked. That was a month ago and for the past few days the lights go on intermittently. Can anyone help? BTW, the brakes were replaced 4 months and just got an oil and filter change this past weekend. I really appreciate any advice.
I thought this was free support. Apparently I was wrong. How did I fix it? Easy, I broke down on the freeway and got towed home on a flatbed! That was easy!!
Posted on Jul 31, 2008
p1320 trouble code , 2000 maxima .was setting off tcs and slip lights , run ruff for awhile, could smell gas strong outside the car. then you could stop somewhere shut it off turn it back on aal lights go off and it runs good ! the trans. never slips when this happens. have replaced a couple off the plug coils when code showed one was miss-firing months ago. it has also givin a code that said random multiple miss-fires in the past. 146k miles
The P1320 code is essentially a coil primary voltage problem. This is traceable using a labscope or accurate DVOM and perhaps you can isolate one or two coils that still work but are close to failure...but there is a nissan service message recommending replacement of ALL coils with updated/improved models to prevent this type of failure. TCS/SLIP is traction control. Most likely you have a speed sensor issue. Be aware, some vehicles can falsely illuminate TCS because of low tire pressure in a single wheel.
Posted on Sep 09, 2009
left rear blinker going at double speed
Posted by wdalley on
I just had that problem with my jeep cherokee and either your bulb has burned out or it is burning out. Time to replace it. Turn the signal light lever on the side that's flashing fast, get out of the vehicle and look at the front and back signal lights and replace the one that isn't blinking...hope this helps.
Posted on Feb 23, 2010
i'm trying to figure out cylinder numbers. There are two different types of ignition coils, don't know which I would need to replace.
Posted by diminick03 on
left and right banks... the right bank is the bank next to the firewall... cylinders 5 & 6 are next to the tranny.
Posted on Nov 16, 2009
if my car is does not have the take off speed of first gear but instead tries to build speed for second gear could this be because the tranny srainer needs to be cleaned or could it just be the shift solenoid B really malfunctioning and causing the car to strain its take off. I'm really trying to avoid getting another tranny. By the way i did get the error code P0755
Request givin for 2000 Nissan Maxima 3.0
Posted by trickstar8... on
go with the new solenoid, in order to change it the trans pan has to come off so install a new filter at that time.
Posted on Jul 17, 2009
Speed sensor location on a Nissan Maxima 2000 gxe
Posted by Guest on
There are two speed sensors one is called a revolution sensor that is located on the case of the transmission. You can take the driver side wheel off and see the sensor on the top of the case of the transmission. A 10mm bolt is holding it in. Easy fix
Posted on Jun 17, 2010
1,967 questions posted
Usually answered in minutes!