20 Most Recent 2000 Chevrolet Venture Questions & Answers

On the high pressure side of the system on the line that goes into the evap just at the engine compartment firewall. Sometimes it is wrapped with an insulation and is hard to find.

2000 Chevrolet... | Answered on May 27, 2019

In order to reach the negative terminal to the battery in a 2000 Vebture (I have one) you must first remove the fuse housing. The fuse housing is a large black box that sits atop the battery. There os a single bolt that holds it in place located in fron of the battery bolted into the lip of the motor bay. Unscrew this, then unhook the fuse housing from the cross bar running from the back roght to the front of the motor bay. This is a tight fit so watch your knuckles. Once the fuse housing is out, the negative terminal is located on the backside of the battery. It is a tight squeeze black is negative, red is positive.

2000 Chevrolet... | Answered on Feb 11, 2019


Click on the link.
You put the starter wires back on the same way they came off. If the wiring diagram doesn't help, not sure where to go from there?

2000 Chevrolet... | Answered on Feb 22, 2018

The button is not working. It's programmed if the other functions (buttons) work. What you can do is take it apart, clean the rubber part (the buttons) with soap and warm water. Then, use a cotton swab and rubbing alcohol to clean the circuit board where the back of the buttons contact the board.

2000 Chevrolet... | Answered on Feb 11, 2018

Are you using the correct key?

2000 Chevrolet... | Answered on Jan 27, 2018

Without testing we'd only be guessing , your best bet ,take it to a qualified repair shop that has the diagnostic skill's an testing equipment . Hooking up a professional scanner .
016 Engine Misfire Misfire Scan Data

2000 Chevrolet... | Answered on Nov 23, 2017


Click on the link.
If you think the problem is a fuse or circuit breaker, I see three fuses and a circuit breaker. Use a test lite and check voltage at circuit breaker and fuses, some are hot all the time, I believe one goes hot with the key on.

2000 Chevrolet... | Answered on Sep 09, 2017

The body control module is causing all these conditions. Have it tested or replaced.

2000 Chevrolet... | Answered on Aug 29, 2017

incorrect firing order for the plug leads
low fuel pressure

2000 Chevrolet... | Answered on Aug 28, 2017

throttle position sensor is bad

2000 Chevrolet... | Answered on Aug 17, 2017

the first thing to do is to have the oil pressure read using a mechanical gauge
that ensures that you know that the engine is running with the right oil pressure
you can test the ECM operation by using a substitute ECM that is a known good unit
run the fault codes to see in the oil pressure sensor is a problem
At this point , test the oil pressure as suggested then change the oil pressure sensor

2000 Chevrolet... | Answered on Jul 13, 2017

get a second opinion from an accredited service shop that has experience on your vehicle
sound like the mechanics at Midas are just parts replace and see you as a sucker customer

2000 Chevrolet... | Answered on Jul 08, 2017

Testing is the way to a fix . Fuel pump pressure testing , electrical testing . Viewing engine sensor data on a scan tool . Instead of guessing as to the problem learn to test or take it to a qualified repair shop . Changing ECU without doing it correctly can cause problems that were not there before . PCM - engine computers need to be programmed , dealer only.
GM Fuel Pump Relay Testing
Testing Electric Fuel Pump Problems with Voltage Drop Test
048 Engine Hard to Start or No Start Scan Data for Starting Problems

2000 Chevrolet... | Answered on Jul 07, 2017

Yes , but it involves taking the vehicle to a chevy dealer ! They would hook up the GM factory Tech2 scan tool . See if any codes are stored ,see if it will communicate with the tool . Should only cost about $26.00 buck .This isn't something for a non trained service tech. to mess with. The window not working is more then likely the regulater binding up . Would need to take door panel off to see what is wrong .
How To Install Remove Door Panel Chevy Venture Pontiac Montana 97 05...
How To Install Replace Power Window Motor Chevy Venture Pontiac Montana 97...

2000 Chevrolet... | Answered on Jun 16, 2017

My guess is a fuse in the fuse panel at the far passenger side of the dash,you have to open the passenger door to check it or ....is the interior light over ride switch above the rear view mirror in the correct position for interior lighting?

2000 Chevrolet... | Answered on Apr 22, 2017

Sounds like you still have a cooling system leak issue like a cracked cylinder head.

2000 Chevrolet... | Answered on Mar 15, 2017

Not finding what you are looking for?
2000 Chevrolet Venture Logo

1,179 questions posted

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Venture Chevrolet

  • Venture Chevrolet

Most Popular Question

2000 chevy venture temperature gauge

  • Cars & Trucks