20 Most Recent
1997 Chevrolet K1500 - Page 2 Questions & Answers
Will a 4l80e fit inplace of a 4l60e with out electrical compont changes
Dtrannyman is correct you not only need to change flange yokes drive shafts but you also need to change or reflash ECM and the wire harness connectors are wired differently better to have 4l60e rebuild for severe service / towing and add an external grant and a transfer case coolers also an engine oil cooler is never a bad idea just make sure all are properly installed my 97 express 1500 van is set up like that and now has over 520000 mi on it 400000 on trans since last rebuild I also recommend mobile 1 synthetic fluid and Lucas additive
Hi,
My name is Hunter,
Possible that it can be due to belt slippage , mainly the fan belt. Stop the engine and check the belt PLAY, if this is more remove the fitting bolts of the tensioner and adjust the tension of tehbelt to tighten it further.
Now if there is still noise coming out while it accelerates then the clutch, brakes or wheel bearings need to checked.
Where is the cam position sensor on a 1997 chevy
The camshaft position sensor (also known as the distributor pickup) is inside the distributor which is driven by the camshaft gear and directly below the water pump, the water pump must be removed to access the distributor to change the sensor. Here is a picture of the camshaft position sensor.
The key is stuck in the on position
sounds like the ignition tumbler. if it is in park and you can't turn key back its the tumbler will have to replace the ignition tumbler and you can get it re keyed to your old key so it should not be to bad
Not finding what you are looking for?