20 Most Recent
1993 Chevrolet S-10 - Page 8 Questions & Answers
Door handle on left side 1993 chevy S10
The rod you are talking about could be for the inside or outside handle which was not mentioned so I will give you both
You will see two tabs with black or rusty spring steel clips attached to the tabs. The one facing upward the most is for the outside door handle. The other is for the inside door handle
The rod will simply push onto the slotted clip to install. Now since the clips are very old and maybe rusty they can break upon installing the rod so new clips can be purchased at any GM dealer if needed
Speedometer turn signal short 94 c1500
First I would go back and check out the turn signal switch to make sure you install that correctly. Look for shorts or wires that could be grounding out. Go to the library and getting a wiring diagram and find out everything that goes to that fuse. Also if the truck is rusty check all the body grounds. Good luck.
I have a 90's S-10 that I have some problems with.
There isn't anyway to bypass it. You will to replace cluster to fix the odometer. As for the gas gauge it could be either the cluster or the sending unit in the tank. It is usually the sending unit in the tank but you need to fix the cluster anyway so I would start there.
Diagram for the firing order on a 4.3 vortex chevy
For the 1993 Chevrolet S10 Blazer 4.3 V6, Both: 2WD AND 4WD:
Firing Order:
1-6-5-4-3-2
Cylinders:
.......(back).......
|..6..|.......|..5..|
|..4..|.......|..3..|
|..2..|.......|..1..|
......(front)
Distributor:
....(back)
(+).4...3
5...........2
..6...1..(+)-screw
.....(front)
Let me know if this helped, or if you have additional information or questions. Feel Free to contact me at FixYa.com!
How can i find a wirilng schematic for 1993 Chevy
You will need a Chevrolet service manual for this model for a complete schematic. People do sell these on Ebay very often which is the cheapest way to purchase one. I seriously doublt if anyone will scan all pages to email to you although it doesn't hurt to ask. I do not have one for yours. If I did I am on the computer 4 hours per night and could scan for you. Maybe someone out there will do it for you
O2 sensors
The O2 sensors are usually located: one near or on the head pipe coming off the manifold; and the other before the catalytic converter. A special socket is needed to accommodate the wires from the sensor. It is not expensive and makes removal and installation easy and correct.
Please rate this answer. Thank you.
Transmission is leaking bad, and front seal has
there's abushing behind the front seal that maybe worn out also the torque converter may have a leak. also the front pump housing has a seal around it or gasket that may be leaking. if it's still leaking from the same area than you should pull the trans back out and check those.
Hi i did a 350 swap in my 93 s10 and now it wont
Try adjusting the transmission rod on the side of the transmission put it in park then put on the e-brake and move the shifter rod all the way forward to park position then it should work. if not you may have bent the shifting linkage when installing the transmission.
My 1993 chevrolet S-10 with a Manual Trans will
Nope the throw out bearing is fine if there is no noise from the bell housing, but it sounds like your clutch is worn and needs to be replaced. Good luck and check to see if your have enough fluid in your clutch hydraulic system and top it off and this may get you a few more days before you get the clutch replaced.
Not finding what you are looking for?