20 Most Recent
2002 Mazda B-Series - Page 9 Questions & Answers
Brake lights stays on
Check switch isn't depressed at pedal. If power going in & coming out, when not depressed, replace switch.
I have a 2000 b2500
NOPE CANT CHANGE ENGINE AND DRIVE TRAIN ITS PCM IS PROGRAMMED FOR 2.5 ENGINE AND DRIVE TRAIN IF YOU CHANGE FACTORY SETTINGS YOU WILL HAVE ALL KINDS OF PCM TROUBLE CODES.
Is there any available insidewall
I'd check with a local used auto parts store (wrecking yard). You might have to buy the entire tailgate, but even that shouldn't be too expensive.
When the speed on the
Could be an air leak in a window seal, or maybe even a speedometer cable?
But you need to narrow it down more.
Take a piece of rubber tubing, listen through it, and move it around where the whistle is loudest, while someone else drives.
I have a mazda b2500
I think this may be normal. The glow plugs are only times for a short duration, and it should not require them very long. Otherwise they would burn out and require replacement all the time. As long as it is fine once it warms up, I would not worry. But if it takes too long to warm up, you may have a bad thermostat. Check by feeling the radiator hoses on a cold engine. One should slowly get warm, while the other should stay cold until it suddenly get hot. If they both slowly get warm, the thermostat is always open.
Hi Guys,
Greetings from the middle
try a new set of plugs in it first,,,,if you can get a compreshion test done on the engine check all the cylinders are the same compreshion if one is low or maybe two to gether are low you have a head gasket on its way to poping out
Bearing in turbo
very hard to get parts not to mention you dont have the expesive tools needed to rebalance it wich is 100% required. no auto mechanic i know or any local machine shop would have this eiher.i tried the same project some years ago and ended up sendind to a turbo rebuilder to get repaired. but an exchange unit is probably available.
Tank full - needle doesnt lift
It sounds like the fuel gauge tank unit has gone open circuit. To be sure, remove the wire from the tank unit and ground it on the frame. Have someone check the panel unit. If the needle goes fully upscale, then the tank unit is your problem.If it doesn't move, it's the panel unit.
Not finding what you are looking for?