20 Most Recent 2002 Mazda B-Series Questions & Answers


max towing capacity is 1.8 tonnes (1800klgs)
The towed should have electric brake control as the mazda has no traction qualities on the rear end under brakes.

2002 Mazda... | Answered on Feb 21, 2015


if it starts by push start and runs then it's obviously a standard. Then it's not your wiring it's your battery. now if your battery drains down quickly, then your starter may have an internal ground . but sounds more like a f ..upped battery.sometimes you may put a battery on a charger, and it may show that it is charged, but in actual fact bateries calcifie over time, and are use less.

2002 Mazda... | Answered on Aug 27, 2012


It is a grease seal, just replace it.

2002 Mazda... | Answered on Jun 29, 2012


Clean all dirt and/or grease from the fuel filter fittings. "Quick Connect" fittings are used on models equipped with a pressurized fuel system. These fittings must be disconnected using the proper procedure or the fittings may be damaged. The fuel filter uses a "hairpin" clip retainer. Spread the two hairpin clip legs about 1/8 in. (3mm) each to disengage it from the fitting, then pull the clip outward. Use finger pressure only; do not use any tools. Push the quick connect fittings onto the filter ends. Mazda recommends that the retaining clips be replaced whenever removed. The fuel tubes used on these fuel systems are manufactured in 5/16 in. and 3/8 in. diameters. Each fuel tube takes a different size hairpin clip, so keep this in mind when purchasing new clips. A click will be heard when the hairpin clip snaps into its proper position. Pull on the lines with moderate pressure to ensure proper connection. Start the engine and check for fuel leaks. If the inertia switch (reset switch) was disconnected to relieve the fuel system pressure, cycle the ignition switch from the OFF to ON position several times to re-charge the fuel system before attempting to start the engine.
0900c15280192eed.jpgRemove the "hairpin" clip retainers to access the fuel line fittingsThe inline reservoir type fuel filter should last the life of the vehicle under normal driving conditions. If the filter does need to be replaced, proceed as follows:
CAUTIONIf the fuel filter is being serviced with the rear of the vehicle higher than the front, or if the tank is pressurized, fuel leakage or siphoning from the tank fuel lines could occur. to prevent this condition, maintain the vehicle front end at or above the level of the rear of vehicle. also, relieve tank pressure by loosening the fuel fill cap. cap should be tightened after pressure is relieved.
  1. Shut the engine off. Depressurize the fuel system.
  2. Raise and support the vehicle safely.
  3. Detach the fuel lines from both ends of the fuel filter by disengaging both push connect fittings. Install new retainer clips in each push connect fitting.
  4. Note which way the flow direction arrow points on the old filter.
  5. Remove the filter from the bracket by loosening the filter retaining clamp enough to allow the filter to pass through.
The flow direction arrow should be positioned as installed in the bracket to ensure proper flow of fuel through the replacement filter.
  1. Install the filter in the bracket, ensuring proper direction of flow as noted by arrow. Tighten clamp to 15-25 inch lbs.
  2. Install the push connect fittings at both ends of the filter.
  3. Lower the vehicle.
  4. Start the engine and check for leaks.
  1. Before servicing the vehicle, refer to the Precautions section.
  2. Properly relieve the fuel system pressure.
  3. Remove or disconnect the following:
    • Negative battery cable
    • Push connect and R-clip fittings from the fuel filter
    • Fuel filter 0900c15280192eee.jpgFuel filter location and connections–2002–2006
To install:
  1. Install or connect the following:
    • Fuel filter. Torque the nut to 17 ft. lbs. (23 Nm).
    • R-clip and push connect fittings
    • Negative battery cable
  2. Start the vehicle, check for leaks and repair if necessary.

2002 Mazda... | Answered on Feb 18, 2012

Not finding what you are looking for?
2002 Mazda B-Series Logo

59 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Mazda Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

B-Series Mazda

  • B-Series Mazda

Most Popular Question

use castrol 15w40

  • Cars & Trucks
Loading...