20 Most Recent 2000 Mazda Protege - Page 5 Questions & Answers

auto shutoff relay..

oil need to reach upper engine components its wear and such..be looking for loose hardware or anything shaking when starting..

for 2000 duel over head or DOHC

here you go.

many things a puddle on tank maybe the unplugged line that if put cap on end the smell will disapear but check your filters along chassis lines bad plastic clips need a change every now and then

i have a 1998 mazda protege my gas line is unplug where is it located

on the backside of the motor, towards the firewall. look above the drive shaft. it's about haft way up the motor.

Go to Oriley's they will give you the codes and the solutions to repair

managment light staying on

I wouldn't be surprised if that was making the noise

Make sure you disconnect the battery first, you don't want to take a chance on setting off the airbag. After you remove the airbag, you will have to remove the steering wheel nut, and steering wheel spokes. You will require a puller to pull the steering wheel off the shaft.

that is TPS (throttle positioning sensor) it's job is to see how much you open the throttle( how much you push the gas pedal) and sends this info to PCM .and pcm tells injector how much more or less gas the engine needs.on some cars it compares this info in conjunction with MAP (manifold absolute pressure) to get the job donehere are the cause1-the spring on throttle body is sticking,or there is corrosionon conectors (MAP or TPS)2-misrouted harness causing chafing3- bad TPS,or conector4- bad pcm(most likely this is not the problem,but it might)have the shop check your TPS and MAP sensors for youor you can google it and check it your selfDO NOT take the TPS out if you don't know how to reset it

The thick rubber hose from the air filter to intake manifold leaks (broken). Replace. Clear compuuter, enjoy

Time to replace, also make sure there is nothing inside the speakers creating these sounds.

This is really hard, because the is no drain plug.Lose the transmission bolts and let out some oil, this is a messy job.Good luck.

I just fixed this problem o my car, and it costs no more than $20 to fix... replace your thermostat. What happens is that the car reaches a certain temperature and the coolant flows to keep the car cool, well if the thermostat doesn't open at that certain temperature, the car runs how and eventually turns off; causing you to wait until it cools down to be able to turn it back on. The fix took no more than 15 minutes and the car runs great now.

you might have wrong belt or you need to make sure you are following the belt correctly where it needs to go. take a picture before you take off anything.