20 Most Recent 2004 Mazda RX-8 Questions & Answers

0helpful
2answers

I recently removed a dead battery from my 2004

Here’s the thing... Rotary Engines are Very Delicate... I Would Suggest Disconnecting The battery for an hour then try again... or get a jump and let it run... should do the trick
3/15/2021 4:57:18 PM • 2004 Mazda RX-8 • Answered on Mar 15, 2021
0helpful
2answers

How do I remove ( as in physically remove) the pats module out of my 2004 mazda rx8?

You can't ! Take it to a qualified repair shop and have it fixed the right way . Removing the pats module will permanently disable the vehicle . If the PCM - engine computer see's no response from the pats module it will not let the vehicle start an run . You have no clue what your messing with .
1/29/2021 1:01:45 PM • 2004 Mazda RX-8 • Answered on Jan 29, 2021
0helpful
4answers

Mazda rx8 rough idle and stalls when at operating

If there are no vacuum leaks, change idle control sensor.
4/9/2019 8:56:05 PM • 2004 Mazda RX-8 • Answered on Apr 09, 2019
0helpful
1answer

I'm thinking about getting a 2004 mazda rx-8 that when its warmed up it will stalled out.

After doing some research there is a high probability that one of the coil packs is bad and isn't making a good connection after enough heat is transmitted between the coil pack and the spark plug. Heat expansion will cause the coil pack to not create the proper amount of voltage and spark. You might also find an improper gap on a spark plug increased voltage being required to create a spark in the chamber.
3/22/2019 8:29:53 PM • 2004 Mazda RX-8 • Answered on Mar 22, 2019
0helpful
2answers

WHERE IS LOCATION OF SLAVE CYLINDER ON 2004 RX8

Normally the slave cylinder is mounted on the bell housing or just inside where the clutch arm is located.
4/30/2018 3:23:02 AM • 2004 Mazda RX-8 • Answered on Apr 30, 2018
0helpful
1answer

Was driving my mazda rx8 2004 and all of the

take it back! it sounds like a common prob with wankel rotary engines the lobe seals are failing but check the spark plugs are correct and in the correct order they are different for each combustion space
3/8/2018 2:59:35 PM • 2004 Mazda RX-8 • Answered on Mar 08, 2018
0helpful
2answers

I have a mazda rx8, the steering is stiff when

on top of the struts under the bonnet is a plastic cover with a nut underneath ,put some engine oil around this nut so it soaks through to the bearinig ,might or might not work dependiing on the fault but its a favourite trick of mine that often works
2/4/2018 8:12:53 PM • 2004 Mazda RX-8 • Answered on Feb 04, 2018
0helpful
1answer

2004 Mazda RX-8 engine light

(TCU) Transmission control module, the fuses/connections are most likely your problem
12/31/2017 7:10:23 PM • 2004 Mazda RX-8 • Answered on Dec 31, 2017
0answers
0answers
0helpful
1answer

My 2003 Hyundai Accent computer

Not a valid trouble code for 2003 Hyundai Accent but it is valid for 2004 Mazda RX-8. You don't replace ANYTHING until you find out why the mixture is too lean. This could be caused by at least 20 different things. If your shop doesn't know how to diagnose the root problem, find a shop that does. If you start throwing parts at this without diagnosing, you could easily drop $1,000 and still not fix the problem.
11/12/2017 7:02:32 PM • 2004 Mazda RX-8 • Answered on Nov 12, 2017
0helpful
1answer

I have a 2004 Mazda RX- 8 starts but sounds like a piston engine while turning over then it starts a then dies. Charlie Rork loxahatchee , Fl.

I’ve had a lot of experience with Mazda RX-8’s... Because I owned one. But your problem could just be the seals of the Rotary.. Try to replace those...
11/6/2017 11:24:14 PM • 2004 Mazda RX-8 • Answered on Nov 06, 2017
0helpful
1answer

My 2004 RX-8 sounds like a piston engine out of time while trying to start finily starts then after 4 or 5 seconds dies. Charlie

l reckon ya timing is out, or it's yer points so best bet is to git yer mechanic to have a look.
11/5/2017 1:32:35 AM • 2004 Mazda RX-8 • Answered on Nov 05, 2017
0answers
0helpful
1answer

I have a 2006 mazda rx8 .it runs good but all of

l reckon ya should see yer auto electrician eh.
10/17/2017 6:07:35 AM • 2004 Mazda RX-8 • Answered on Oct 17, 2017
0helpful
1answer

Immobilizer 2004 RX8

go to the given link this will provide you the repair manual with it's help you can solve the problem http://toolsnyou.com/
8/24/2017 4:47:01 AM • 2004 Mazda RX-8 • Answered on Aug 24, 2017
0helpful
1answer

I have a 2004 Mazda

Pull the door panel off and inspect the door latch, it is most likely defective.
4/21/2017 9:43:42 PM • 2004 Mazda RX-8 • Answered on Apr 21, 2017
Not finding what you are looking for?

863 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Mazda Experts

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8991 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6963 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15009 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

RX-8 Mazda

  • RX-8 Mazda

Most Popular Question

remove as in physically remove pats

  • Cars & Trucks
Loading...