20 Most Recent
2003 Ford Mustang - Page 2 Questions & Answers
Where can I get a diagram of the intake manifold runner control?
Do a Web search under the terms (Your make, model, year vehicle) intake manifold runner. Or intake runner control solenoids, rods, etc. You may find Youtube videos.
The runners are sandwiched under or inside the intake manifold. Some had plastic clips which crumbled and the operating rods became disconnected. Some runners stuck too bad for the rods to move them.
7/3/2015 3:59:09 PM •
2003 Ford...
•
Answered
on Jul 03, 2015
Where is the fuel relay located
The fuel pump relay is located it what ford calls a CCRM - Constant Control Relay Module , It is under the hood in the engine compartment ! An looks like this !
3/13/2015 12:42:05 PM •
2003 Ford...
•
Answered
on Mar 13, 2015
What would cause my 03 4.6 mustang To not take fuel but it will idle
You may need to change your fuel filter. It could be dirty enough to not let enough fuel pass through. Could also be a weak fuel pump. I'm not sure if your vehicle has one but your throttle position sensor could be bad. I would try fuel filter first. Take it off and let it drain and watch to see what color the fuel is when it comes out. If it's anything other than clear I would replace it. Hope this helps.
2/6/2015 1:33:41 PM •
2003 Ford...
•
Answered
on Feb 06, 2015
Anti theft device
Try the other (spare) key. it could be just the transponder has failed in that key. if not it will be a tow to the dealer problem.
1/21/2015 7:24:52 PM •
2003 Ford...
•
Answered
on Jan 21, 2015
2003 Mustang V6 Basic
I installed model
Hello . I have done some checking on this . The kit should have come with instructions . You might try to look up the manufacturer online and see if they have the wire diagram you will need to make it a little more easy . If you go to youtube and input under video search " Mirrors presented by Andy's Auto Sport " a video will come up that will show you basically what you need to do . Since your car was not equipped with turn signals in the mirrors you will have to run the wireing under the dash to just below your steering column . There you will have to find what wire runs the left turn and what wire runs the right turn and splice into them with the mirror that matches . Your mirror should have a power for light which will connect under dash and a ground which you will ground to the metal body of your car under the dash ( look for a bolt or nut that you could connect this to ) . I hope this is helpful to you .
11/17/2014 5:39:23 PM •
2003 Ford...
•
Answered
on Nov 17, 2014
Not finding what you are looking for?