20 Most Recent 1994 Ford Crown Victoria Questions & Answers

0helpful
2answers

The ignition switch on my 94 Ford Crown Victoria turns freely without stopping at the positions. it starts but will not turn off. What is the problem?

you may not have the rod in the correct position so it pulls and pushes. the key has to push to start and pull the rod back to turn it off. you may have to reinstall the key lock cylinder with the rod in the right place.
11/17/2022 11:02:30 PM • 1994 Ford Crown... • Answered on Nov 17, 2022
0helpful
3answers

I have a 94 vic lx. Cruise control has worked

since the fuses are ok i would try the servo this is the piece that looks like two face. it has a solid back on one side and a rubber front on the other it should be around your master cylinder. check to make sure that the wires arent frayed or have come loose.
5/19/2022 8:08:09 PM • 1994 Ford Crown... • Answered on May 19, 2022
0helpful
1answer

How do I open the engine compartment fuse box on a 1994 crown victoria

Those generally have a pull tab you hook with the tip of ya finger.
1/30/2019 3:34:35 AM • 1994 Ford Crown... • Answered on Jan 30, 2019
0helpful
1answer

The passenger door won't close correctly and when I do get it closed the light underneath the desk by the floor and the light on the door wont go until about 20 or 30 minutes later

If you lift the door while closing does it close better? can You move the back of the door up and down easily? If so ,your hinge bushings are worn and need replacing. The lights aren't going out because the door is never closing properly.
11/18/2017 6:45:35 AM • 1994 Ford Crown... • Answered on Nov 18, 2017
0helpful
1answer

Ford 91 crown victoria car auto transmition small

Sensor maybe? Maybe torque coverter isnt locking out.
9/19/2017 12:43:57 AM • 1994 Ford Crown... • Answered on Sep 19, 2017
0helpful
1answer

It have a 1994 crown victoria it ran out of gas I

Air in the fuel line. Take one small wire off the starter relay and turn and hold the key in the start position for a while. Listen for the fuel pump. It will run fast for a second then slow down. When it does, put the wire back on the starter relay and crank the engine.
8/29/2017 5:03:18 PM • 1994 Ford Crown... • Answered on Aug 29, 2017
0helpful
2answers

1994 crown victoria engine races

Problem with idle speed. The idle is controlled by the pcm (engine computer) through the operation of the Idle Air Control valve or motor. But several other sensors are also at work, like the throttle position sensor, the coolant temperature sensor, the MAP sensor or the Mass Air Flow sensor. The computer monitors all engine conditions to optimize performance and driveability-this includes keeping idle speed correct. Would probably help you if you could see what all those sensors are telling the pcm-so you need a scanner capable of giving live stream data. And don't forget, your '94 is OBD-1, not OBD-II like all cars since 1996 on have. A garage should have such capable scanners, but they are kind of high end, not your typical cheap code scanner.
5/7/2017 10:56:41 PM • 1994 Ford Crown... • Answered on May 07, 2017
0helpful
1answer

Negative voltage at tail lights

Thanks Syntax Error for letting us know you figured out the wiring harness was wired incorrectly. It is always a good idea to look up the color wiring standard for the socket and to check the pin positions and what functions . Sometimes trailers can be wired incorrectly also ? I wired the licence plate bulb to my brown wire by mistake and this is the brake wire . Took a while for me to figure that one out !
5/5/2017 4:55:54 AM • 1994 Ford Crown... • Answered on May 05, 2017
0helpful
1answer

94crownvictoria back and front passenge has pooled water,i have no idea from where or is this commonr

Your heater core is bad, and its leaking from under the dash !
11/8/2016 3:09:32 PM • 1994 Ford Crown... • Answered on Nov 08, 2016
0helpful
1answer

Are the front (wheel) bearings sealed?

Front wheel bearings on larger older rear wheel drive cars are very rarely sealed. Repacking the bearings is a regular maintenance procedure. I've checked a few youtube videos and here's a Good one that describes the process. https://www.youtube.com/watch?v=5BBwu2c1rLA Cheers
3/15/2016 6:02:17 PM • 1994 Ford Crown... • Answered on Mar 15, 2016
0helpful
1answer

Where are the freeze plugs located. how many does it have?

3 on each side of the engine. 2 between the engine and transmission, 2 on the heads. 3 one the side of the engine are hidden under the engine mounts and behind the starter.
2/13/2016 1:09:33 AM • 1994 Ford Crown... • Answered on Feb 13, 2016
0helpful
1answer

Blue smoke coming from tailpipe

If it is only occurring at start-up, you may only have some leaky valve seals. This is a problem that can wait a while for repairs, until other internal engine work is needed. Just watch the oil level. If it is a constant thing, and you are seeing a relatively unusual oil consumption, then you are most likely seeing oil burning from worn piston rings and/or cylinder walls. If it gets bad enough, an engine rebuild is in order.
10/21/2015 11:05:35 PM • 1994 Ford Crown... • Answered on Oct 21, 2015
0helpful
1answer

How much oil does trans hold

a full flush and refill specification is 10 quarts
9/28/2015 5:02:52 PM • 1994 Ford Crown... • Answered on Sep 28, 2015
0helpful
1answer

Does stop smoke really work for engine

It might, for a while. Unfortunately, these are temporary measures that are not repairs, but are cover-ups for the more serious issue that hasn't been addressed. In some cases, these products can actually do more harm than good, as they are designed to plug up leaks from small gaps. Sometimes they plug the wrong gaps and cause other problems. The real solution is to properly repair the problem. If that is not feasible or you are trying to nurse a dying horse a short while longer, than weight the benefits versus the risks and roll the dice, and hope for a good result. I, personally, would not use such products in my own vehicles.
9/19/2015 7:09:36 PM • 1994 Ford Crown... • Answered on Sep 19, 2015
0helpful
1answer

Where is the fuse for wipers

Instrument panel fuse box number 2 fuse 8.25 amp
9/19/2015 6:38:39 PM • 1994 Ford Crown... • Answered on Sep 19, 2015
0helpful
1answer

How do i fix a flashing overdrive light and an OBD2 code PO743 in Ford Crown Victoria

Check the wiring on the TCC Transmission Converter Clutch solenoid at the trans and the PCM . It is possible the PCM is bad . BBB Industries online has free wiring diagrams for this model.
7/7/2015 12:45:45 PM • 1994 Ford Crown... • Answered on Jul 07, 2015
0helpful
1answer

How do i replace the motor mounts on my 1994 crown

I can only forewarn you about several things to watch for in hope of providing you with something to prevent you from breaking something. You must also consider loosening the transmission mounts to free up the entire drivetrain. There may be some clearance problems at the rear of the motor and the Radiator hoses may not stretch, nor may the fixed A/C lines to the front A/C cooler allow much travel space. The oil pan is not a lifting point, nor is the crankshaft pulley. The exhaust system is not flexible either. Your best bet is to look at the actual motor mount and see whether the mount is flush or has protruding studs. Flush shaped will be easier to handle. An 1/4 inch of clearance would allow you to slide parts through the opening. You could still get another Expert to answer. I owned a 1994 Crown Vic and was underneath it many times, but never changed a motor mount on it.
4/14/2015 11:46:39 AM • 1994 Ford Crown... • Answered on Apr 14, 2015
Not finding what you are looking for?
1994 Ford Crown Victoria Logo

430 questions posted

Ask a Question

Usually answered in minutes!

Top Ford Experts

Marvin
Marvin

Level 3 Expert

85241 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22509 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15083 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Crown Victoria Ford

  • Crown Victoria Ford

Most Popular Question

freeze plugs located many

  • Cars & Trucks
Loading...