20 Most Recent 1993 Mazda 929 Questions & Answers

connect a amp meter in line to the compressor clutch cable, operate air con and check amps, should not above 12 amps .

1993 Mazda 929 | Answered on Apr 04, 2017

problems include
cam/ crank sensor failures
immobilizer not operational
flat fob key battery
broken timing belt /chain
ecm problem
no fuel pressure
run the fault codes to find the area ans sensors at fault

1993 Mazda 929 | Answered on Jan 08, 2017

Here is a vid that shows the location as well as adjustment procedure.

1993 Mazda 929 | Answered on Jan 02, 2015

Clean or replace the idle air control motor and also clean the inside of the throttle body. use brake clean and a toothbrush.

1993 Mazda 929 | Answered on Dec 28, 2014

Headlight switch probably the problem. One circuit is shutting off when the other turns on. If it was a fuse or relay, it would just turn off...

1993 Mazda 929 | Answered on May 14, 2014

First drain radiator fluid, then follow the lower radiator hose from the radiator to the engine. At the end of the hose it will lead to a metal thermostat housing. It's held on by 3 bolts. Remove these 3 bolts and pull away thermostat housing with hose. Take notice of the way the thermostat is positioned before removing. Its best to do all this while laying down, looking up.

1993 Mazda 929 | Answered on Aug 26, 2013

Hi Shannon, befor you dive in and replace the indicator switch I would suggest you check the flasher unit. To replace the indicator switch you will need to remove the steering wheel (this usually means using a puller) Don't forget to punch match marks on the steering wheel and the column which must be aligned when assembling. Remove the steering wheel center cover. then the covers on the steering column Removed the screws (usually four) holding the stalk switch. don't forget to disconnect the battery and the wiring connection to the stalk switch. After replacing the assembly is opposite.to dismantling. Regards John

1993 Mazda 929 | Answered on Nov 09, 2011

your vehicle has a cold start valve,, and they aren't cheap, but thats what causes this issue in a Mazda 929, Check this link ,, http://www.theautopartsshop.com/auto+car-usa+parts/mazda+929+fuel-injection-cold-start-valve.html

1993 Mazda 929 | Answered on Sep 21, 2011


1993 Mazda 929 | Answered on Sep 19, 2011

car wont start

1993 Mazda 929 | Answered on Sep 08, 2011

Hello and welcome to FixYa!

As a first course of action, I strongly suggest that you have the battery charged. It can be an indication of a weak battery or a faulty alternator. If the battery light still on after charging then the problem will surely be on the alternator itself. If that's the case the alternator should be replaced to resolve the problem.

You may try to reset it to by removing the positive battery connector, letting it sit for at least 5mins. then reconnect it again. This will reset the system and can get the battery light off.

Hope this helps and thank you for using FixYa! Have a good one!

1993 Mazda 929 | Answered on Jun 06, 2011

try disconnecting - battery terminal for 10 seconds should clear codes

1993 Mazda 929 | Answered on May 23, 2011

Not finding what you are looking for?
1993 Mazda 929 Logo

68 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

1992 Mazda 929
1992 Mazda 929

86 Questions

1994 Mazda 929
1994 Mazda 929

74 Questions

1995 Mazda 929
1995 Mazda 929

25 Questions

1990 Mazda 929
1990 Mazda 929

21 Questions

1991 Mazda 929
1991 Mazda 929

21 Questions

Top Mazda Experts


Level 3 Expert

85239 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14866 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

6576 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

929 Mazda

  • 929 Mazda

Most Popular Question

1993 mazda 929 checked battery starter

  • Cars & Trucks