20 Most Recent
2004 GMC Yukon Questions & Answers
Parking brake too soft on my GMC Yukon 2004.
If there is no other adjustment available for the cable, It sounds like your cable is stretched. It happens after years on older vehicles. While you can do things to make it tight, it probably would be better to replace it with a new cable. I found some on eBay for just over 20.00 up to around 50.00 each that are supposed to fit the Yukon. Old stretched cables can snap/break allowing the vehicle to roll.Parking Brake Cable For Select 00-06 Cadillac Chevrolet GMC Models 1479-02742 (Fits: 2004 GMC Yukon)Autopart International 1479-02742 Multiple US LocationsBrand New$21.99Save up to 25% when you buy moreList price: Previous Price$27.99??21% offBuy It NowFree shipping
How do I convert 2004 GMC Yukon transfer case to traditional 4x4 (2h, 4h, 4L) rather than current AWD?
changing your denali awd to reg is more about the electronics than the trans swap out --you ll need the harness --switches and reprogram/flash the computers --mounts--cross members and other brackets and such ----oin one of the many forums like tahoe--yukon etc this is one of a few on the subject --------https://www.performancetrucks.net/forums/gm-drivetrain-suspension-22/denali-awd-conversion-4wd-482852/--
Where is the (wiper) delay module?
It is the control module on top of the windshield wiper motor. The multifunction switch provides a specific DC voltage to the control module for each delay and speed.
Further testing would be necessary to determine the cause.
See first half of following video for access to the motor.
https://youtu.be/RvXltkEfHOw
What causes a battery drain in 2004 Youkon
check the instrument panel fuse. when the vehicle is completely turn off and timed out. mine will draw about 200mA of current... I suspect the IP has fractured solder joints from GM using lead free solder, it does not hold up to vibration well at all. right now i'm removing the fuse when off... reflowing solder connections with real tin lead solder... so far I got my transmission indicator lights.
02 GMC Denali front heated seats won't work
The controller could be bad but I would probe the related wiring first. From your symptoms it sounds like something can not handle the electrical load. You turn the F/R seat heater on but then you turn on the F/L and the whole system fails. It does sound like the source of the problem will be under the drivers seat. Testing needs to be performed to confirm and identify the source. Both seats share the same fuse and ground. This circuit may have a damaged wire or connector somewhere. Inspect and test as much as you can. Also look underneath the seats for anything. Customers are not aware that personal belongings and trash get pushed underneath the seats and will damage wiring. Also excessively moving the seat forward and back will weaken the harness over time. Please write back and let me know what you need. If it is more diagnostic information or suggestions just let me know. Good Luck
2004 gm yukon wont crank.
It is not necessarily the flow of gas that is important. You need at least 40 pounds of pressure for the injectors to operate correctly.
Not finding what you are looking for?