20 Most Recent
1995 GMC Yukon - Page 5 Questions & Answers
Lost reverse in my 1995
I'd try replacing the shift modulator before any thing else. $20 screws in to side of ****** with vacuumn hose attached
Took all the wires off
1-8-4-3-6-5-7-2 is the firing order for a v8 chevy, look at the cap locate the number one on it, tunk the starter and note rotation, and wire accordingly... chevy is odd numbers on the drivers side 1-3-5-7 and evens on the passenger side 2-4-6-8
What is the timing for
Hello waxx1128,
The timing is 0 degrees TDC.
Below is the procedure for setting the timing.
I hope this helps.
Regards,
netvan
1995 yukon power merrors not
Check fuse and then switches. Probably not the motor but possible . Get from a junkyard if needed.
FixYa Support
Abs lite comes on after
you need a can tool to test out the code, i know
this tool is helpful for your car. or you can take your car to the local car dealer to test it. hope help.
The hydrocarbons emissions are to high
Bad plug or wires, or bad catalytic converter can do this.
Also a rich mixture from a bad temp sensor could do it.
Temp sensor checked with ohmmeter.
Bad ones usually go 0 or infinite.
After parking my 1995 GMC
The fuel is not reaching the engine and the gears are bit worn out.They are not engaging.Both the fuel lines and gears need a inspection.----------
---------
The car parked on the hill for so long time has cause the problem to gears, they are not engaging and fuel is also not reaching, when the car is towards uphill.-------
I suggest get the fuel pressure and fuel lines inspected, also get the gears checked, if checked out faulty, then get it replaced.---------------
This should help.Thanks.Helpmech.
1995 GMC Yukon Loss of
if your pads are good all around and your fluid is full replace your master cylinder and bleed the brakes all around
if it helps please leave good feedback it helps us help you
Lost reverse in my 1995 GMC Yukon 4wd. Other gears
Usually when you loose reverse in this transmission it it because the reaction shell strips or breaks do to high line pressure caused by a P01870 code being pressent.Another common cause is the needle bearing on the input drum/shaft breaks up and the pieces get lodged in the reverse input drum and keep those clutches from applying.Long and short is there is no simple fix,adjustment,or sensor that will keep you from having reverse.It is time for major transmission repair.Let me know if I can help in anyway.Thanks David@FIXYA
Lighting Issue
Sounds like you either have a bad headlight switch or a bad relay under the hood. Also you might want to try turning the lights on for a minute without the motor running,if they work with motor off then its probably the headlight switch.
Not finding what you are looking for?