20 Most Recent
1995 GMC Rally Questions & Answers
Truck hood stuck
well when you pop it from inside does it hit the second latch, or not even that, when you pop it try hitting the front center of the hood with palm not like really hard, but with some umf
I need to remove the
it is usual in the bottom of the head rest if not it would be right where the bar is u push it in and it will let it slide out
Replaced 73 GM, 350 cu.
If the voltage was measured at the starter terminals and the starter motor spins, check if there is voltage going to the plugs. Pull out the hi-tension wires from the engine and put it over the block and see if you get a blue arc for each of the cylinders. If you are getting good arcs inspect if you are getting fuel into the cylinders. You are most likely using carbs, check if you are getting fuel to it. Otherwise inspect the line and if you are using a fuel pump check if you are getting fuel to the fuel filter when you have the key to the run position or when starting. You may also just need to replace the fuel filter if ever it is dirty. Check the wiring for loose connections especially ground wires.
I have a light showing
the warning light on the dash relates to the lambda probe(o2 sensor)failure,easy to fit.
1988 gmc rally G series van cannot remove int. door handle
There is a horseshoe shaped clip that is on the back of the window crank handle. There is a special tool you can buy to slide behind it and remove it or you can pry out gently on and using a small screwdriver or pick you can pop the clip off. You may need a flashlight to see it but it is quite simple to remove. Turn the handle until you can see the open side and just push on it with the screwdriver and it will pop off - watch for it as it is easy to loose. To put it back on put the clip on the handle first then just push it on the shaft. If you do happen to lose it you can buy them at NAPA
Not finding what you are looking for?