20 Most Recent 1998 Pontiac Grand Am - Page 5 Questions & Answers

The terminlas and conectors are good and clean, exist continuiity and Charge, makes noise trying to start

110 foot lbs of tourqe buddy

WHAT ARE YOU NEEDIN TORQUE SPECS FOR?(WAT PART).

ignition components are heating up from resistence caused by age--worn coil is common-havit testd--ignition module 2nd--the injector drivers in the computer 3rd

it is behind engine in front of passenger side

Bade battery or bad connection not getting good power to starter

oil could be present on rear brake. clean it with brake cleaner. sand paper rear drum brake. try again if it lock

If the light sockets do not have power, it could be the turn signal switch.

Does the fan not come on at all, or not until the temp is above 230 degrees ? And do you know if the computer is sending a ground signal to the relay at 220 degrees ?

Trun the ignition kley off and on without starting the engine to purge the air from the system, do this about 10 times.

True the coil pack

Have you determined if the power booster is working or not ?

oxygen sensor is going bad.

REPLACE THE 4 WAY FLASHER.. IT CONTROLS BOTH. There is one BEHIND THE HEATER CONTROLS but replacing the one by your Fuse Box will fix this 95% of the time.

If it's the 4 cylinder pull the 4 bolts out of the engine top coverand disconnect the connector on the drivers side,pull it straight up,the plugs are under there. Make sure the engine is cold to preventgalling of the aluminum head.