20 Most Recent 1997 Mercedes-Benz Mercedes Benz Sl Class - Page 3 Questions & Answers

you need to take out the inside door panel and then you have access to the handle fixing parts.

Autozone has two batteries to choose from
Duralast Gold part #H8-dlg
Duralast part #dl-49
you can go to autozone.com and prob order it right from there

In most cases it is called a "3-2 Shift Solenoid" and it is located inside the tranny. I would take the vehicle to a Mercedes dealership and for about $30.00 they will confirm this by using a computer diagnostic device. I feel that most dealerships have better equipment for detecting this kind of problem.Then after you can decide on a repair garage of your choice to do the job!

Hi,
Oxygen Sensor Location - Under vehicle, passenger side, below seating area, front of catalytic converter, mounted in exhaust pipe.
Procedure to Replace

• The sensor is threaded into the exhaust manifold.
• It can be difficult to remove unless a special anti-seize compound is coated onto its threads.
• Torque the sensor to 30 foot-pounds using a special socket.
• A sensor that is too loose or a cracked exhaust manifold can result in a lean signal to the computer.
• Check the vents in the thimble of a replacement O2 sensor.
• There should be the same number of holes and they should face clockwise or counterclockwise like the ones on the original sensor.
• Installing the wrong sensor can result in slower cross counts.

Let me know, if needed further assistance.
Hope i helped you.
Thanks for using ' Fixya ' and have a nice day!!

you should be able to look and answer your own question. Do you see bushings?

sounds like a leaking seal inside the trans, but have a trans shop road test it to be sure, they will do that for free in most causes as they want the job of repairing it.

The control units do fail with some regularity. Have you checked them.

roof on my sl 500 will not open electrially,

at the bottom of coolant container their is a electrical sensor clean wel.l unplug fill back up

I had the same problem. One day I opened the hydraulic resevoir under the spare tire to check the level of the hydraulic fluid and voila' the top started to work fine. It opened and closed perfectly. It has worked fine now since July. The only thing I did was open the resevoir. Perhaps there was some kind of air block!

I solved my own problem by accident! I checked the hydraulic fluid under the spare tire and voila' the top started to work fine! It has worked perfectly now since July!

Question edited for clarity. Question moved to make model category. https://fuse-box.info/mercedes-benz/mercedes-benz-cl-class-s-class-c216-w221-2006-2014-fuses-and-relay More here https://www.google.com/search?q=2007+Mercedes+Benz+SL550+fuse+box+diagram ..

hmm... as i remember u have to STEP on the small pedal near the left wall and CLUTCH pedal?

Ask Mercedes on the internet this question.

These are cable driven there is a cable that goes into the rear differential its probably the sender unit thats gone on the diff side the 190e are the same type i think you can buy these and replace easy enough its just 1 hex nut that keeps it in place hope this helps ivan