20 Most Recent 1995 Chevrolet C1500 Questions & Answers

0helpful
1answer

Does a 1995 chevy C1500 truck 5.7L engine have a transmission modulator valve

It has a shift solenoid. It's about $30 from Amazon. 4L60E Transmission Shift Solenoid Valve
3/9/2019 8:02:58 PM • 1995 Chevrolet... • Answered on Mar 09, 2019
0helpful
2answers

Rear brake and rear turn signals not working

"...one light goes on another off." is the clue. The problem is either * a break in the harness or harness connector; or * a loose contact in the circuit board connector; or * a crack in a trace on the circuit board; or * poor grounding. You may need a magnifying glass to find a circuit crack, and a small soldering iron to fix it.
1/20/2018 2:22:49 PM • 1995 Chevrolet... • Answered on Jan 20, 2018
0helpful
2answers

Passenger headlight dim /only on low beam

Depends on just how dim it is. If not too dim, I would first make sure the bulb is the same brand/model you have installed on the other side. It is very unlikely it's a problem with the dimmer switch, but may be a problem with the headlight relay or connector pins at the headlight.
11/2/2017 6:26:16 PM • 1995 Chevrolet... • Answered on Nov 02, 2017
0helpful
1answer

1995 Chev pickup emergency flashers don't work

Probably have to replace the whole switch.
8/23/2017 12:03:37 AM • 1995 Chevrolet... • Answered on Aug 23, 2017
0helpful
1answer

Pilot bearing adjustment for the forks on a 1995 chevy c1500 with a 5-speed nv3500

You're speaking of the throw out bearing - the pilot bearing is in the end of the crankshaft that the front tip of the input shaft rides in. Do you have a mechanical or hydraulic clutch? If mechanical, there should be some adjustment provisions in the cable or linkage. If the linkage had been adjusted for a worn clutch, it may not have enough movement to release a new (thicker) clutch. If hydraulic, make sure you have bled the hydraulic lines and slave cylinder to eliminate any air bubbles. Air is compressible and prevents the full movement of the slave cylinder to release the clutch. I don't ever recall working on a throw out bearing actuator arm that has an adjustable pivot. Not saying there aren't any, but I've not seen one.
8/1/2017 11:46:03 PM • 1995 Chevrolet... • Answered on Aug 01, 2017
0helpful
1answer

I have a 1995 Chevy CK1500. The truck would not

it sounds like the cable may be mis routed , making it tighter , or just may be to short , return cable and try another, hope this helps
5/6/2017 11:46:09 AM • 1995 Chevrolet... • Answered on May 06, 2017
0helpful
1answer

I have a 95 silverado c1500 with 4l60e trans and it wont go into overdrive

overdrive is the fourth gear.D1,D2,D3,D4 now drive truck at 80 kmh cruise at steady speed no fuel pedal movement, downshift from D4 to D3 you should feel RPM raise .. after push brake pedal a little you should see RPM raise 300 to 400 rpm. shift pattern is 1st gear ,second gear,3rd gear and lock up(torque converter clutch). 4th gear with lock up hope it helps
4/15/2017 8:38:36 PM • 1995 Chevrolet... • Answered on Apr 15, 2017
0helpful
1answer
0helpful
2answers

Where is the turn signal flasher on a 1995 Chevy Silverado?

On my 95 Chevy 1500, the 4way flasher is located in fuse panel on firewall driver side under dash. To get to the turn signal flasher, remove the bottom dash panel and the entire ash tray compartment. I also removed the cup holder unit to allow light. The turn signal flasher was located just below the the radio and AC area. Mine was wrapped in tape from the factory, but if you turn the turn signals on you will feel the vibration and be able to locate it from the sound.
6/25/2015 1:04:28 PM • 1995 Chevrolet... • Answered on Jun 25, 2015
0helpful
2answers

My truck won't kill,it cranks just fine but when we remove the key from the ingition all the power on the inside of the cab is off but the truck is still running. What could cause this?

My first guess would be a faulty ignition switch. There could also be a short in the wiring - there has to be power going to the fuel pump relay and the ignition to keep it running. You should be able to turn the key on and off and check those circuits with a meter or test light.
6/16/2015 3:14:52 AM • 1995 Chevrolet... • Answered on Jun 16, 2015
0helpful
2answers

Spark chevy tbi

Down deep in the distributor there is a pickup coil did anyone check or replace it ? I find its easier to pull the distributor but mark position first.. then replace the pickup coil in the distributor.. that's about last thing to replace sounds like you have done the others.
3/26/2015 4:03:42 PM • 1995 Chevrolet... • Answered on Mar 26, 2015
0helpful
2answers

What shuts off fuel system when in wreck

This truck uses a high pressure fuel system, key must be on for the electric fuel pump, which is in the tank, to work. Fuel pump senses when pressure drops, so that it will shut off if there is full pressure, and engine not running. If there is lower pressure, such as a broken line, it will continue to pump, if the engine is running. If you're asking if it has a safety feature shutting it off in an accident, no it does not, except if the engine shuts off due to the accident, fuel pump will not work, unless key is turned off and then back on, and will then work for about 5 seconds and shut off, unless engine is started. If you're asking why the fuel pump doesn't work after an accident, it's most likely damaged, or a wire has been damaged, OR the computer maybe damaged (therefore telling it to turn on/off when key is on and engine running with key on and pressure is low, or at the right level to run the engine. Again, if you turn the key on and do not start the engine, fuel pump will work briefly for about 5 seconds to bring pressure up to where it can be started, then the fuel pump will work again when the engine is started (so the fuel pump isn't running with the engine off for very long.)
3/19/2015 2:58:39 AM • 1995 Chevrolet... • Answered on Mar 19, 2015
0helpful
1answer

Is my starter bad

I'd check for voltage and ground for the starter. Any testing at the starter make sure tranny is in park or neutral and the parking brake is set. Some of the national brand autostores will test the starter for you, if you take it off and take it to them. The battery has a full charge? Can you turn crankshaft by hand?
2/24/2015 5:07:10 PM • 1995 Chevrolet... • Answered on Feb 24, 2015
0helpful
1answer

I replaced the battery in my 95 chevy truck,it will barely turn over,it does not turn fast enough to start

Have you had the starter tested ? Cables in good condition ?
2/24/2015 1:07:11 PM • 1995 Chevrolet... • Answered on Feb 24, 2015
0helpful
1answer

1995 chevrolet pickup 1500, how do I remove the bed?

There are 6 bolts that hold the bed on to the frame. Remove them all and the wire harness plug and it will then be free to come off.
12/6/2014 6:52:47 PM • 1995 Chevrolet... • Answered on Dec 06, 2014
0helpful
1answer

1995 chevy silverado c1500 air conditioning unit blowing hot air - what to do

There are 2 pressure switches on the refrigerant lines. Pull off a connector and short the wires on the connector. If the clutch engages then the pressure switch is bad.
12/6/2014 6:43:14 PM • 1995 Chevrolet... • Answered on Dec 06, 2014
0helpful
1answer

Whywill truck fire but is not getting fuel where is the crank trigger located?

Check the ignition module, located in the distibutor.
10/2/2014 2:05:23 PM • 1995 Chevrolet... • Answered on Oct 02, 2014
Not finding what you are looking for?
1995 Chevrolet C1500 Logo

285 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Chevrolet Experts

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6929 Answers

john h

Level 3 Expert

25236 Answers

Ryan Lutton
Ryan Lutton

Level 3 Expert

1267 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

C1500 Chevrolet

  • C1500 Chevrolet

Most Popular Question

truck kill cranks just fine but when

  • Cars & Trucks
Loading...