i have a nissan maxima 95 mdel,it stalls some time when i slows down,sometime at idle when this happens it will be difficult to start the engine again,i changed fuel pump,fuel filer yet problem is not soleved
Posted by okwuchi4li... on
Every answer here is wrong. This has been driving people nuts for 15 years. The problem is the engine wiring harness which has a bend going past the right strut tower, Nissan had a service bulletin on this in September of 1999, Google it, it's in pdf.
Posted on Aug 23, 2009
My car shuts off sometimes when put in reverse. It does this usually after it has been driven. It hasn't happen in the mornings. Its weird because I can restart it, put it drive, and take off with no problem and it idles good. Now if I put it reverse after going forward it will stay running. Need some suggestions Please.
dear friend-i think what your car needs is conditioner to soften the seals and valve body,if this does not work you wil have to remove the valve body and clean.
Posted on Jul 26, 2009
I drove my car from work to home, stopped for less than 2 minutes and turned off car. I went to start it back up and it will not start. We tried to jump it, and nothing. I have power completely, it won't turn over. I had the starter, battery, and alternator check last week and was told by an Auto Zone worker that all was good. Any suggestions? My father is thinking it could be the ignition switch. How would we test this?
Posted by jendav28 on
You may have bad solenoid, starter/battery/solenoid connections, or gound.
Check voltage at starter solenoid when somebody turns key to start. That is where the starter switch, or relay, sends the voltage to pull in the solenoid coil through small wire. I think the solenoid is on the starter for this car, but it may be separate. Autozone has an excellent web site with car-specific repair guides and instructions. You should see 12V at solenoid every time the key is turned to start.
Check big power cable to starter that runs direct from the battery for tight connections. If you have a separate solenoid, then another big cable runs from it to starter. A loose or bad connection could be the culprit. Also check starter mount bolts. They need to be tight for a good solid electrical ground. You also need good ground from frame to engine. Its a long shot, but sometimes the ground straps come loose or burn. You can easily check this by measuring resistance between engine block and negative battery terminal. It should be zero or darn near zero (less than 1 ohm ?).
The solenoid is really a heavy duty swich to handle the high amp load to the starter. It works by a coil that pulls in the big switch. The coil operates from the starter switch and needs onlyt low current and small wire. If the coil wires burn up or there is a bad connection, it won't work. Hope this helps.
Posted on Jan 25, 2009
how too remove back seat in a 1995 Nissan Maxima
See Figures 3, 4, 5 and 6
Fig. 3: Pull up on the front of the lower seat cushion and disengage the clips
Fig. 4: Remove the bolts behind the center armrest ...
Fig. 5: ... and the bolts on the lower corners ...
Fig. 6: ... Then pull up on the seat to disengage the three clips on the top of the seat
Hope help with this (remember rated this).
Posted on Jul 19, 2010
what is the valve clearance of nissan z20 engine?
Posted by radagle on
VALVE CLEARANCE ADJUSTMENT
Application In. (mm)
Intake .010-.013 (.26-.34)
Exhaust .011-.015 (.29-.37)
Posted on Mar 20, 2009
How do you remove alternator from 1995 Maxima
Posted by scaddingd on
Hope this helps!
Fig. Fig. 1: The large positive lead connection is protected by a rubber boot
Fig. Fig. 2: Make sure the alternator ground wire is also removed
Fig. Fig. 3: Remove the lower adjustment bolt ...
Fig. Fig. 4: ... followed by the upper pivot bolt. Make sure you support the alternator
Fig. Fig. 5: Using a C-clamp to push in the pivot bushing will make installation easier
Posted on Apr 08, 2009
Car: Nissan Maxima SE 1997 I was driving along at about 65mps when the tachometer/RPM gauge suddenly went from 2000 rpm to over the redline and then stayed there even though I brought the car to standstill and engine was normal. The tachometer needle is still at 8000+ RPM
how can I fix the tachometer?
Posted by a1thaker on
the dash voltage egulator probably went bad. First,check the battery & make sure you have 12 volts,not running. Check it again running & you should see about 14.5 volts. If that's good,I'd replace the guage assembly.
Posted on Jun 28, 2009
How to reset the anti theft system in a 1995 maxima
Posted by darnellhan... on
I read somewhere I believe in Maxima Forums if you turn the ignition key to the ON position...not starting the car, and leave it on for ten minutes minimum without touching anything it will reset itself.
Worth a shot.
Posted on Dec 01, 2013
What type of oil does a 1995 nissan maxima take?
Posted by hpunk65 on
you can put any brand of oil as long as its 5w-30 hope that will help you
Posted on Jan 21, 2011
its leaking on the passenger side, like the top side of the oil area where the oil goes in at. I was told it was a camshaft position sensor and i could replace the O ring
Posted by T. T. on
if your car has alot,saying that im talkin 200.000 plus miles on it poss could be that sensor o ring,they very rarley fail unless lots of miles on drive train.without knowing how bad the leak is or any other pertinant info, like any recent service done? how long has it been leaking? does it only leak while running?while running under a load? or just sitting? all off the above? my guess would be valvecover gasket,front cam seal,oil fill cap, cyl head gasket? with just the info at hand to go on it could be any of these things pretty much in that order,if you can do a little more investigative work to answere some of the questions i asked you should get a verry accurate answere and poss things to address along with whatever maintenence needed to remedy the leak .
Posted on Jul 05, 2012
1,541 questions posted
Usually answered in minutes!
Step 2: Please assign your manual to a product: